No you would have to connect the car to a Computer(OBD1 Or ORD2) depending on the year of the car, and reset the code.
p0108 is map sensor signal high. Replace map sensor
Replace sensor and clear code.
Check all your wiring for your map sensor, if ok replace the map sensor.
low pressure on you MAP sensor clean it or replace it
how to replace a map sensor on a 2004 dodge intrepid.
can you tell me were the map sensor
That is a MAP sensor code, check to see if the sensor is returning at least .5 volts, if not check for 5 volt reference voltage on the connector. If you have voltage going in, and none or less coming back out replace the sensor, if no reference voltage check the connectors, wiggle them and monitor the voltage. If the wiggle test checks out, draw a vacuum on the MAP sensor vacuum port. As you add vacuum the voltage should decrease. With no vacuum, the MAP sensor should read around 4.5 volts. If there is no change in MAP sensor reading on the scan tool, replace MAP sensor.
ck for vacuum at map sensor hose, if it is vacuum present replace the map sensor.
the map sensor is located on top the intake manifold and reads off map sensor just disconnect wire then get a Philips screw driver and take off then replace and put back on
Don't think yours will have a MAP sensor. It will have a MAF sensor, and it is attached to the air filter housing.
MAP sensor circuit low.MAP sensor circuit low.
I have the check engine light on and the code is for map sensor on my 1999 1500 Chevy suburban