Auto Parts and Repairs
American Cars
Emily Osment

If your 1992 Plymouth Voyager automatic makes a noise like the whole bottom is dragging but it stops when you speed up what is wrong?

293031

Top Answer
User Avatar
Wiki User
2015-07-16 19:19:36
2015-07-16 19:19:36

Noises are hard to diagnoise unless heard. Take it to a machanic.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The 1997 Plymouth Voyager low pressure valve is located on the bottom of the air conditioner compressor. The low pressure valve has a hose connected to it.

User Avatar

It is on the bottom of the fluid reservoir.It is on the bottom of the fluid reservoir.

User Avatar

Hey Teresa==It is on the bottom of the engine, GoodluckJoe

User Avatar

on the front of the engine at the bottom near the oil filter.

User Avatar

There should be a small valve at the bottom of the rad.

User Avatar

1995 and before comes out the top. 1996 and later come out the bottom.

User Avatar

My 1998 PLYMOUTH GRAND VOYAGER has 2 pumps one for the front and one for the back. They are both located in the bottom of the reservoir.

User Avatar

Bottom of trans inside the pan.Bottom of trans inside the pan.

User Avatar

It is located on the lower bottom left side of the engine near the crankshaft.

User Avatar

One above the tank, and a screen on the bottom of the pump.

User Avatar

on the bottom of the washer tank good luck email me boy_dane @yahoo.com

User Avatar

At an auto salvage yard most likely. You can also try eBay motors.

User Avatar

You have to remove the belt first, this is easiest with a tensioner tool. Then the nut that holds it to the bracket is on the backside of the tensioner and needs to be done from the bottom.

User Avatar

It is quite likely that she is egg-bound.

User Avatar

It is on the bottom of the reservoir.

User Avatar

if your replacing the tank then just punch a hole in yhe bottom with a center punch, or disconect fill neck and rent a tank to suck it out

User Avatar

not if you are mechanically incl. its on the trans bell housing near the motor on the backside of the trans. its probably easier to get to by going through the bottom of the vehicle by jacking it up and putting it on stands.

User Avatar

Looking at the engine there is a bottle on the driver side against the firewall with a long neck pointing towards you. Remove the yellow cap and fill to the line. When in doubt of the line fill to the bottom of the neck.

User Avatar

Remove wheel, remove cotter pin at bottom of tie rod, remove castle nut. Separate tie rod from spindle. Unscrew tie rod, Screw in new one, seat in spindle, install castle nut, install cotter pin, install wheel, go get a beer.

User Avatar

On the bottom of the engine, towards the front of the car. Not as easy to get to as it was for the 1995 and earlier caravans. I vae chnged a few in the 1998's, not that fun because it is difficult to get to and to get starter out of car.

User Avatar

Remove the wiring harness from the bottom of your 1996 Mercury Cougar automatic antenna. Remove the retaining nuts at the bottom of the antenna. Reverse the process to install your new automatic antenna.

User Avatar

up to 1995, out the top. 1996-2000, out the bottom.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.