The bulb is falty, replace it and it should cure your problem.
There are separate flasher relays for the hazard lights and turn signals. The flasher relay may be out on your blinkers. The relay for the hazards is behing the fuse box. The relay for the blinkers is behind the lower dash panel to the right of the steering column.
Your flasher relay is shot and you need a new one.
The flashed in a 1991 Plymouth voyager, is generally located in the driver's seat. They would normally drive round wearing a large over coat, and flash his penis at passers by.
Utah Flash Mob - 2011 Flash Mob Sundance 1-1 was released on: USA: 30 January 2011
the flasher that causes the turn signals to flash But where is the flasher located on this car?
Wire in a turn signal flasher in series with the circuit you wish to flash. The flasher has two terminals. Just insert the flasher anywhere in the circuit. It will make/break the circuit to make the lights flash. This is considering that the circuit is 12 volts and not 120 volts.
replace turn signal flasher, hazard flasher is separate
It makes the signals and the hazards flash.
Did you try changing the flasher?
change the flasher relay
he doesnt
Many mistake the hazzard flasher for the turn signal flasher. Maybe you replaced the hazzard flasher? Also, a burned out bulb will not give enough electrical resistance to the circuit, and result in a very slow or stopped flash. Since your flasher is most likely mechanical, turn on your hazzards and put your fingers over the flasher unit. If you feel it click on & off, then you need to find the turn signal flasher.. because you are touching the hazzard flasher.