0
What else can I help you with?
What do I do on my 1990 Mazda 323 when the key won't turn in the ignition anymore?
i suggest u either get a new key or ignition
Your 1990 Mazda 626 dx died while you were driving it won't start has no spark you changed the cap but not the rotor what next?
Replace the ignition coil.
What is the firing order for a 1990 Mazda van?
4 cyl----1-3-4-2
Power brake 1990 Mazda 929 fails?
929 1990 Mazda power brakes fails
Transmission in a 1990 Mazda rx7 convertible automatic?
Yes, there is a transmission in a 1990 Mazda RX7 convertible.
How do you remove the ignition lock cylinder in a 1990 Mazda 626?
To remove the ignition lock cylinder in a 1990 Mazda 626, first, ensure the steering wheel is unlocked and the key is in the "ACC" position. Next, locate the release pin or screw on the side of the ignition switch assembly; you may need to remove some trim pieces to access it. Use a small tool to press the pin or remove the screw while simultaneously pulling the ignition lock cylinder out. Finally, disconnect any wiring harness if necessary and replace the cylinder as needed.
Testing ignition coil for 1990 Mazda mx6?
To test the ignition coil on a 1990 Mazda MX-6, first disconnect the negative battery terminal for safety. Remove the ignition coil from the vehicle and use a multimeter to measure the primary and secondary resistance according to the specifications in the service manual. Typically, the primary resistance should be around 0.4 to 2 ohms, while the secondary resistance should range between 6,000 to 15,000 ohms. If the readings fall outside these ranges, the ignition coil may be faulty and should be replaced.
What is the firing order for a 1990 Mazda B-2200 Fuel injection Truck?
Engine firing order 1 - 3 - 4 - 2
What is the wiring order for a 1990 Volvo 240 electric ignition?
For a 1990 Volvo 240 with an electric ignition, the typical wiring order for the ignition coil is as follows: the positive terminal (B+) connects to the ignition switch, while the negative terminal (B-) connects to the distributor. The distributor should be wired to the spark plugs in the firing order of 1-3-4-2. Make sure to consult the vehicle's service manual for specific details and diagrams, as variations may exist.
How can one replace a cornering light on 1990 Mazda 626 dx?
How can one replace a cornering light on 1990 Mazda dx
Where is the egr valve located on a 1990 Mazda mpv 6 cylinder?
There is no egr valve on a 1990 Mazda MPV 6 cylinder
Where can I find a used 1990 Mazda Miata on line?
There is a great website that has many listings for used 1990 Mazda Miatas. The website is Lemonfree.com and they have several listings for the 1990 Miatas.
