answersLogoWhite

0


Best Answer
Copy

The rear air also runs off the freon from the front air so more than likely you either have a restriction in the rear lines or maybe a temp blen door problem at the rear unit remove interior trim panel and see if the actuator that controls hot to cold door is working may be just a blend door failer.

this truck should hold roughly 5 lbs of freon.

-i once had this problem in a savana(same setup) and the filter before the dryer(front) was blocked up by someone that previsouly used AC line sealant. The ac lines must be opened to change this filter, unfortunately

User Avatar

Wiki User

โˆ™ 2015-07-15 19:03:35
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: In a 1993 Chevy SUV K2500 the front air is cold the back air is hot how do you recharge the rear air?
Write your answer...
Submit

Related Questions

93 Chevy suburban fuel tank capacity?

The 1993 K2500, 4wd with a 7.4L engine has a 42 gallon tank.


Is it possible to make a 1993 Chevy k2500 into a duelly using the same rear end?

Yes, You will just need the spacer assembly from a duelly. (and some SERIOUS fender flares)


How do you replace front fender on a 1993 Chevy silverado?

very carefully.


Do you have to replace the hub on a 1993 Chevy k2500 if you need to replace the wheel bearing?

If, after close inspection you do not see any damage to hub, you can use it. But ALWAYS install new bearing race with bearing.


What size is the dash speaker of a 1993 Chevy blazer?

4x6 in the front dash


How do you remove front coil springs on 1993 G20 Chevy van?

ejaculate on them


How do you recharge the air conditioner on a 1993 Lexus ES300?

can some tell me where the port is the 1993 lexus so I can recharge air conditioner


How do you recharge the air conditioner in a 1993 Chevy Lumina?

Connect the Freon bottle to the low pressure port on your air conditioning compressor. Release the Freon into the compressor. The purchase of a Freon recharge kit will make the process quite simple.


Will the front clip of a 1993 Chevy 1500 bolt on to a 1991 GMC 2500?

yes


What is the front wheel hub torque specs for 1993 Chevy 1500 2x2?

120 lbs


Will the front clip of a 1993 Chevy 1500 pickup bolt on to a 1991 GMC 2500 pickup?

It sure will.


Where is the fuel pump and fuel pump relay located on a 1993 Chevrolet K2500 6.5L Diesel Pickup?

The fuel pump is located inside the gas tank on a 1993 Chevrolet K2500. To access it the tank will have to be removed. The relay is easier to access and is found under the driver side dashboard.


What is the gross vehicle weight rating of a 1993 gmc suburban K2500?

It is 8,600 standard, or 9,100 maximum. Lbs


1993 Chevy Suburban temperature sensor located?

It is in the driverside head between the front 2 spark plugs.


Locate the water pump on a 1993 Chevy blazer?

It is the part that the fan bolts to, on the front of the engine GOOD LUCK


How do you install a starter on a 1993 Chevy Corsica?

Begin by removing the positive cable from your 1993 Chevy Corsica battery. Remove the cables on the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.


What carburetor does a 1993 Chevy Cheyenne 1500 have?

A 1993 Chevy does not have a carburetor, it is fuel injected.


Can a 1993 Chevy beretta automatic transission be towed?

Yes. Lift the front tires. The rear wheels are free-spinning.


Where is the AC air filter on a 1993 Chevy Lumina?

The accumulator which is the filter for the a/c system is located on the drivers side in front............


Location of ignition module for 1993 Chevy Corsica?

The ignition modual is in the front of the engine compartment, below the front manafold between the motor and the radiator above the starter


Where is the timing chainbelt on a 93 Chevy lumina 3.1 v6?

The 1993 Chevy Lumina 3.1 liter engine timing belt can be found on the front of the engine. You will need to remove the front engine cover in order to access the timing belt.


How do you replace the starter on a 1993 Chevy Cheyenne?

Remove the positive battery cable from your 1993 Chevy Cheyenne battery. Remove the two cables from the front of the starter. Remove the three starter retaining bolts. Reverse the process to install the new starter.


where can i get a seat for a 1993 chevy grumman stepvan?

where can I get a seat for a driver for a 1993 chevy grumman truck


Where is the IAT sensor on a 93 Chevy s10 blazer?

The 1993 Chevy S 10 Blazer IAT sensor can be found on the top of the transmission. The IAT sensor will be near the front of the transmission.


Where is the low pressure recharge valve on the 1993 gmc surburan?

Its on the a/c accumulator..............