25 thousand volts
voltage is the amount of energy an electron carries
1meter
Please give examples.
Any type of device that would need to be converted from AC to DC power would use a voltage converter. Devices such as televisions, monitors, and other electronic devices could use a voltage converter.
fly-back transformer.
Colour picture tubes use a shadow mask, or aperture grill, to ensure each electron beam lands on theright phosphor - same principle as a pin hole camera. But the shadow mask blocks a significant proportion of the beam. A higher accelerating voltage helps overcome that effect.
We're talking about high voltage when we talk about the operating voltage of a cathode ray tube (CRT). The operating voltage can vary, as you can imagine. Tens of thousands of volts are not uncommon.
It's basically a highly specialized transformer.
Picture bowing and bending on a projection TV is usually caused by an out-of-spec power supply voltage that is not providing sufficient voltage for proper screen deflection. Seek qualified service for this unit.
The TV flyback transformer is obsolete in modern television sets and is not used.In the old cathode ray tube (CRT) television sets the flyback transformer had two functions:generate a large and powerful current pulse to drive the horizontal deflection coil in the yoke around the neck of the tube to create a quick horizontal retrace between sweep linesusing a large secondary autotransformer winding produce a very high voltage (i.e. 15KV to 100KV) rectified by a high voltage diode needed by the anode of the CRT to accelerate the electron beam
if electric field is used then we have to apply a very high voltage ,or we may require a very long tube.however ,if a magnetic field is used ,even a small field can produce large deflection ,on the other hand ,the required size of the picture tube will be highly reduced .due to this reason,the magnetic field is uesd to deflect the electron beam in T.V. insted of the electric field.
Excessive STATIC electricity from the high voltage charge used in the picture tube.
the power consumption of device is constant (provided no any condition is changed) at low voltage the power draw by motor is same at rated voltage bu according to formula the current is rise .
Answer: Generating a picture on a TV employs a different technology than that of a video card for PCs. Today's television picture tubes have shadow masks that are manufactured from a nickel-iron alloy called Invar; while lesser quality sets have masks of iron. The alloy allows the tube to operate at a higher temperature without distorting the picture, and higher temperatures allow brighter pictures. Rare-earth elements have also been added to the phosphor coating inside the tube to improve brightness. The electrons are fired by three tubular, metal electron guns that are carefully seated in the neck, or narrow end, of the tube. After the electron guns are placed inside the tube, the picture tube is evacuated to a near vacuum so air does not interfere with the movement of the electrons. The small opening at the rear of the tube is sealed with a fitted electrical plug that will be positioned near the back of the set. A deflection yoke, consisting of several electromagnetic coils, is fitted around the outside of the neck of the picture tube. The coils cause pulses of high voltage to direct the scanning electron beams in the proper direction and speed.
it accelerate the motion of electron emitted by the filament if given a positive charge, similarly if negative voltage to grid the current flow through the grid is reduced. the more positive grid shows less current.
Alternator is defective.
voltage is the amount of energy an electron carries