Want this question answered?
It gets brighter and brighter - until it burns out.
It would depend on the circuit diagram. In some cases, the circuit would be incomplete (simplest case is a battery with a wire attached to just one terminal).Parallel branches that have a connection to the battery without going through other branches are independent of each other. Say you have two parallel branches and a battery. If you short circuit one of the branches, the other branch will not be affected but the battery will be (current through the battery would decrease because taking out a parallel branch increases resistance).In short, it would depend on the circuit diagram. Note that for a nanosecond, there would be current in an open circuit, but after this brief time there would be no current flow in the segment of the circuit that has been shorted.
A circuit is complete whenever current can flow from the battery (or what is producing current), through the circuit, and back to the battery. A complete circuit could contain just a battery and one wire. An incomplete circuit could be a battery with a wire attached to just one terminal, because current cannot flow all the way through the circuit in this case (i.e. cannot flow through the battery). note: not all elements in a circuit may have current flow in a complete circuit. For instance, a light bulb may be shorted but you still have a complete circuit.
The battery is the power source of the circuit. It supplies current to the circuit and the circuit is simply a path for the current to follow. When you remove the current (battery), the path still exists but there is no current going through it.
If the 3-ohm resistor is the ONLY thing in the circuit, then the current flowing through it is (12 volts)/(3 ohms) = 4 amperes. If there are other things in the circuit besides the resistor, then the current depends on all of them.
you can make it brighter by adding another battery/cell
The bulb will get brighter
Positive and Negative Terminals.
Positive and Negative Terminals.
The bulb becomes brighter unless it is too much till it shot-circuits.
Positive and Negative Terminals.
We did this experiment in class, the more batteries added, the brighter the bulb will become!
The purpose of the battery in a circuit is to wive energy to the circuit
no
It gets brighter and brighter - until it burns out.
The purpose of the battery in a circuit is to wive energy to the circuit
If the alligator clip from the test light is attached to the negative post of the battery it will light up whenever the probe end touches a positively charged circuit and likewise if the alligator clip is attached to the positive terminal of the battery the test light will light up when the probe end touches a negatively charged circuit