In networking there are two version of IP addresses . IPV4 address that is internet protocol version 4 uses 32 bits. IPV6 address that is Internet protocol version 6 uses 128 bits .
The networking protocol that uses a 32-bit address is an IP (Internet Protocol).
IPv4 is an abbreviation for Internet Protocol version 4, which is a 32 bit addressing method. IPv6 is an abbreviation for Internet Protocol version 6, which uses 128 bits.
There are 4 numbers, such as 192.168.1.254 Each number can have a value 0-255, which is 8 bits (00 - FF hex). 8x4 = 32. I do not know if they string all the 32 bits together, or if there are separator bits, though.
only uses one byte (8 bits) to encode English characters uses two bytes (16 bits) to encode the most commonly used characters. uses four bytes (32 bits) to encode the characters.
32 Bits 4 Octets with 1 Byte each(8 Bits)
32 bits (for IPv4), or 128 bits (for IPv6).32 bits (for IPv4), or 128 bits (for IPv6).32 bits (for IPv4), or 128 bits (for IPv6).32 bits (for IPv4), or 128 bits (for IPv6).
Indirect addressing needs 2 reference to memory
A 386SX processor has 16-bits and 386DX has 32-bits
In IP version 4, an IP address has 32 bits, or 4 bytes.In IP version 4, an IP address has 32 bits, or 4 bytes.In IP version 4, an IP address has 32 bits, or 4 bytes.In IP version 4, an IP address has 32 bits, or 4 bytes.
32 bits in a IPv4 address
A byte is 8 bits. Thus, 32 bytes is 256 bits. Bits are each either a single 1 or 0. By statistics, you then have 2256 possible combinations. In other words, 32 bytes can represent any number from 1 to 1.15792089 × 1077.
Following facts determine the use of addressing bits of an instruction: Number of addressing modes: Sometimes an addressing mode can be indicated implicitly. In other cases, the addressing modes must be explicit, and one or more mode bits will be needed. Number of operands: Typical instructions on today's machines provide for two operands. Each operand address in the instruction might require its own mode indicator, or the use of a mode indicator could be limited to just one of the address fields. Register versus memory: The more that registers can be used for operand references, the fewer bits are needed. Number of register sets: One advantage of using multiple register sets is that, for a fixed number of registers, a functional split requires fewer bits to be used in the instruction. Address range: For addresses that reference memory, the range of addresses that can be referenced is related to the number of address bits. Because this imposes a severe limitation, direct addressing is rarely used. With displacement addressing, the range is opened up to the length of the address register. Address granularity: In a system with 16- or 32-bit words, an address can reference a word or a byte at the designer's choice. Byte addressing is convenient for character manipulation but requires, for a fixed-size memory, more address bits.