You will need a multimeter and instructions on how to use it.
It generally reads RMS value of the voltage being measured
Voltage is measured with a voltmeter.
It actually never is measured in series on a meter. AC can be measured by a meter clamp where is the coupling of flux can be measured. A normal meter will read the small voltage drop cause by current flowing through a series resistance. this small voltage drop will indicate current flow the magnitude is a function of scaling.
Inductance is not negative. It is measured in henrys, and that is a positive value. Inductive reactance, however, is measured in ohms, and is commonly shown as negative to indicate that the current lags the voltage.
Ripple is measured in terms of the peak-to-peak voltage variation in an AC signal, typically expressed as a percentage of the average voltage level. It is often quantified as a percentage of the DC voltage or as a specific value in millivolts. Lower ripple values indicate a more stable voltage supply.
ummm... ...voltage?
It is measured using a Voltmeter
The voltage measured across a dry cell is the total voltage output of the cell, typically around 1.5 volts. When three bulbs are connected in series, the total voltage drop across the bulbs will be the same as the voltage output of the dry cell. So, the voltage measured across the dry cell is equal to the voltage drop measured across the three bulbs in series.
Voltage is not measured in ohms. It is measured in volts.
The voltage measured across an open in a series circuit is the equivalent of the sourse voltage.
Power (P) = Voltage (V) x Amperage (I) Written as P=VxI or to find Voltage V=P/I Voltage is measured in Volts (V) Amperage is measured in Amperes (Amps or A) Power is measured in Watts (W)
Use a voltmeter with a high input impedance and measure at the source the voltage.