Is ist possble to view the vibration specturm.
The vibration usually measured on the bearings of machine because bearings are often the place where damage occurs and where symptoms first develop. Vibration measurements are usually taken at machine bearings, with accelerometers mounted at or near the bearings.
No, not by the average home mechanic. Bad compressor? Replace the entire unit.
Lack of lubrication, deterioration of lube oil properties, foreign particles and thrust load of the driver may cause the air compressor bearings to go.
Josiah D. Knight has written: 'Vibration control in turbomachinery using active magnetic journal bearings' -- subject(s): Magnetic bearings, Journal bearings, Vibration damping, Actuators, Shafts (Machine elements), Strain gages, Turbomachinery
Nothing if the compressor bearings are good. Just unplug the wires at the compressor or pull the fuse. If the compressor is locked up or the bearings are shot, then you need to purchase a belt for a 1997 Pontiac Sunfire that came from the factory without A/C. Install the belt, bypassing the compressor, and just leave the compressor alone.
Already a leader in the industry, Timken became the undisputed heavyweight of U.S. ball bearings with the 2002 acquisition of industry leading Ingersoll-Rand's The Torrington Co.
Yes, but I do not know of anywhere that they are sold.
This is not cost effective. It's quicker and cheaper to replace the compressor.
Wheel bearings are the most common for causing a vibration.
No, only the compressor will lock up.
Yes, if the compressor's bearings are bad, usually accompanied by a roaring or squealing noise coming from the compressor's pulley.
Yes, the wheel bearings or CV joint could be bad.