Want this question answered?
No
change your distributor. its just a part inside there next to the ignition coil
how do you install a bank 1 sensor 2 for an 1998 acura tl
There isn't one.
The camshaft position sensor on a 1991 Acura Legend is located at the back of the camshaft, near the rear bearing cap. It monitors the rotation of the camshaft and relays this information to the vehicle's computer.
The crank position sensor can be found in the front of the crank on the engine block below or next to the water pump in many applications. It can also be located on the main crank pully or the flywheel. The orientation of each make and model's engine is different, so the position sensor could be near your fender or near your front bumper depending on the car. They are typically made of magnets and oil and work on the principles of the Hall Effect. Resource: http://www.redlinemotive.com/replacement/acura/crankpositionsensor.asp Note: I am replacing mines on the 99 Acura Integra GS. No difference between the Ls though.
Most likely a Throttle position sensor
How to install a boost gauge in a acura integra?"
It is an integral part of the distributor. Changing the part is as expensive as buying another distributor. Just change the distributor, that way the whole piece gets some form of warranty where as the CPS(or CAS "cranks angle sensor") is usually considered a solo electrical part and has no warranty, what so ever.
Drain the radiator. Remove the drive belt, and the crankshaft sprocket cover. Unbolt the pump, replace it, then re-install the cover and belt.
How do you install an after market stereo in a 1989 acura legend?
where do you install a new flasher for a 1991 Acura Legend?"