Transmission shift linkage installed incorrectly or out of adjustment.
Yes.
autolite 4 barrel with vacuum secondaries .
numrich gun parts or Ithaca guns U.S.A
50-100 USD or so
yes
No. Also, Marlin does not sell the barrel for the 882 as a component part. The Model 17 barrel can be installed, but again finding the barrel is a problem. The existing barrel can be relined to .17HMR. sales@countrygunsmith.net
Chevy says about 210hp.
50-100 USD or so
A vent rib is a metal sighting plane attached to the top of the barrel from the receiver to the end of the barrel at the muzzle. They are usually a quarter inch wide and may have small grooves along the top. The venting means that it is raised above the barrel slightly to allow air between the rib and the barrel which helps the barrel to keep cool. "Factory" simply means that it was originally installed at the plant that manufactured it. In trhis case either in Belgium or Japan. Many times aftermarket vent ribs are installed which hurts the value of a gun rather than increase the value. A factory installed vent rib increases the value vs a plain barrel.
no the throttle bodies are diffrent i have the same problem
no there is no governor. but it does need modification to the throttle barrel in the carb! take off air filter and look in the hole should only be able to see about 5% of the throttle barrel. but you will most likely see more then 50%... less air less fuel = very slow bike.. haha.. probably does about 35mph... fix the barrel and you should see about 50 to 55mph shaunpo pocket bike specialist.. 7/13/2011
It shouldn't. You should only use products manufactured for your firearm on that firearm.