No, if the UL Rated Listing for the Panel is 200A than that's it. You cannot have 300A flowing through a 200A Panel.
bed
Absolutely not. #2awg conductors are only good for about 100 amps depending on Cu or al. see nec table 310-16.
According to voltage drop calc.you would need to run a 900mcm cable min. for 200 amp 240 volt Every cable has loss because every cable has resistance. It is basic physics.
A 3/0 copper conductor with an insulation factor of 90 degrees C is rated at 225 amps.
200A
200 is composite.
No, if the UL Rated Listing for the Panel is 200A than that's it. You cannot have 300A flowing through a 200A Panel.
250 mcm
STABILIZED WIEN BRIDGE OSCILLATOR (The 200A)
HVX 200a with an xtreme fisheye.
1.A 2.c 3.d 4.b
You must bridge the channels
bed
Absolutely not. #2awg conductors are only good for about 100 amps depending on Cu or al. see nec table 310-16.
250 MCM aluminum minimum
In conduit? direct burial? distance?