According to voltage drop calc.you would need to run a 900mcm cable min. for 200 amp 240 volt Every cable has loss because every cable has resistance. It is basic physics.
Ir is the Interrupt rating of the circuit breaker. It is the maximum amount of current the breaker can withstand without damage. In a molded case breaker's electronic trip mechanism, Ir is the continuous current rating that you select, to trip the breaker at a given overload current. Standard requirements request that the breaker trips at 2 hours with an overload of 135% and will trip as a function of I squared x time selected for higher currents.
Some breakers can trip totally off. If the breaker is continually turning off without a wiring issue, then the breaker could be going bad.
The circuit breaker is used to protect the conductor that is connected to it from an overload condition. On a motor load the breaker has to be sized 250% of the motors full load amperage. Some circuits can be only loaded to 80% capacity and this is governed by the sizing of the breaker. Without knowing what the load amperage is, this question can not be answered.
Your only hope is that someone wired the box not to code and that there are two wires going into the offending breaker. If you can't separate wires you can't distribute the load.
The sizing of the circuit breaker and hence the wire size to feed the pump are all dependant upon the amperage of the pump. This question can not be answered without that information.
Without being a Moshi Member it's not possible to play the dancing game in the Underground Disco.
A miniature breaker is just two breaker that fit into one breaker slot. These types of breakers are designed to install the same as a full size breaker. Different types of breakers have different mounting configurations to the panels bus bars so installation instructions are not possible without knowing the make and type.
this is impossible without cheating, even with cheating it may not be possible.
Without being a Moshi Member it's not possible to play the dancing game in the underground disco.
No. Not possible.
Sinnoh underground uses DS wirelless communications not Wi-Fi You need another DS and another Pokémon Diamond/pearl to use it completely
There is no possible way to do so without a gameshark. Yeah some are avoidable, but there are always required fights no matter where you go...
actually, it's possible to live without a heart, but you must have it replaced by another thing that circulates your blood.
yes
Yes.
turn breaker off. unhook thermostat wire to furnace turn breaker on. worth a try; if it works you will have to turn off breaker to shut it down.
If you put a 85 amp breaker in there it will overheat from the starting and stopping of the motor. The extra size of the breaker insures that the furnace will run without interruption and without overheating the breaker. And electric motor can draw three times the amperage rated on start up momentarily. This is why there is need of extra amperage ratings.