0
Is Hydroplaning best controlled when you speed up and make drastic control inputs?
Wiki User
∙ 12y ago
ture
Aurelia Stracke
Add your answer:
Earn +20 pts
Introduction multiplexer demultiplexer?
A multiplexer, commonly referred as an input selector, is a circuit with many inputs but only one output: it has some data inputs, control inputs and one output, depending on the control inputs, one input from the data inputs is sent to the output .A demultiplexer is a circuit with one data input, few control inputs and many outputs, it is also known as output selector.
What is the circuit diagram of the traffic lights?
It is not really a circuit, traffic lights in todays world are controlled by programable logic controllers or a plc. There are rungs of logic to control the changing of the lights which are known as the inputs and outputs where the voltage is controlled to change the lights from red to yellow and green.
What interacts with each phase in the conversion of inputs to outputs?
Control
What is the Role of feed back in control system?
The control system a inputs a setpoint which represents the desired value of whatever is being measured, and inputs the feedback signal to determine the actual measured value. The difference between the two is used to calculate the error term. The error term in turn causes a change in the output that drives controlled device until the measured value equals the setpoint, and the error term is zero.Without feedback then, the control system is blind, and is unable to tell whether changes in the control output are having the desired effect.
How will you experimentally check the theoretical predictions in the preceding question?
Using a controlled, scientifically-designed experiments to test theories under laboratory conditions; therefore, the ability to control for certain influences is limited or non-existent. With experiments, scientists can fix some inputs and measure the effects of other inputs in a way that allows ceteris-paribus comparisons.mcukamam
What is a radio control car?
A radio controlled car or R/C car is a powered (electric or gas) model car driven by a radio control system. Inputs from joysticks (or a wheel and a trigger) on a transmitter are sent to the car's onboard receiver. Radio controlled cars can range from simple "stop and go" cars to competitive racing models, which feature all the complexity and adjustability of a full sized racing vehicle.
Are the control inputs on a 74148 active high?
Active low (0-0.8v)
What is circuit control?
It is a circuit that controls some aspect of a system. In a car there may be multiple control circuits such as anti-lock brakes. It takes various inputs, processes the inputs and produces some control outputs, like pulsing the various brakes and assessing the results.
What is a control circuit?
It is a circuit that controls some aspect of a system. In a car there may be multiple control circuits such as anti-lock brakes. It takes various inputs, processes the inputs and produces some control outputs, like pulsing the various brakes and assessing the results.
What is the correct RPM for a jeep grand Cherokee 1995 when the engine is on parking?
Idle speed is computer controlled and should be between 600 and 1000 rpm's depending on PCM inputs.Idle speed is computer controlled and should be between 600 and 1000 rpm's depending on PCM inputs.
Which are examples of inputs to the monitor and control project work process?
Containers Contractors Environmental
Timing setting for a 2000 Chrysler 2.7?
i don't think the timing is adjustable on that car. It's controlled by the computer and is based on inputs from sensors.
