The vehicle load is supported by the springs, or if so equipped, torsion bars. But the ball joint or joints take a good deal of stress from steering and especially driving on rough or bumpy roads, transmitted through the wheel and steering knuckle.
It depends on the suspension setup. Which ever ball joint/control arm has the spring load is the load carrying ball joint.
The ball joints connect the hub to the control arm. They are the load carrying part for the weight on the vehicle.
I was carrying the load up the hill.
Yes, here is an example....... I was carrying the load up the hill.
Pulling a trailer requires more energy than carrying a heavy load.
The load arm is the radius of the pulley. This is the distance from the fulcrum to the load-carrying side of the rope.
Ya jack it up,remove the the wheel,under the hood,remove the two 18 mm nuts from the control arm near the strut,remove the cotter pin and nut from the upper ball joint and smackit with a hammer,and install new control arm with ball joint. I saved a sht load doing it myself.and it only took about an hour.dont get raped by those aholes
Your forks should be as close to the ground as possible when carrying a load to ensure stability and minimize the risk of tipping. When not carrying a load, your forks should be raised to the height recommended by the manufacturer to prevent damage to the forks and improve visibility.
The Edmund Fitzgerald was carrying a full load of taconite iron ore pellets.
carrying power
The question itself is not correct.It should be what is the ultimate load carrying capacity of bored pile?Ans: Ultimate load carrying capacity of pile could be determined be conducting load test.Ultimate load:The load at which the pile continuously settle.orthe load at which settlement of the pile reaches 10 percent of its diameter
350kg