0
Is it OK to disconnect the positive connection on the battery when replacing the harmonic balancer on a 2006 Kia Sorrento?
Tinamcollette
It is recommended to always disconnect the negative cable from the battery first and reconnect it last when the job is done.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What problems can occur after replacing a harmonic balancer?
how to replace harmonic balancer 3.4 v6 2001 grand am gt?
Does the harmonic balancer need to be removed when replacing a timing belt?
Yes
Why does your 91 Buick century idols high after replacing harmonic balancer?
sounds like you broke the crank sensor that is mounted right behind the balancer.
How do you remove the harmonic balancer in a Nissan Maxima?
To remove the harmonic balancer from a Nissan Maxima, first you need to removed the center bolt. After that, you can use a puller to remove the harmonic balancer. Before you do this, make sure you disconnect the battery and remove the drive belts.
Do you have to take of harmonic balancer when replacing water pump on a 97 Chrysler Concorde 3.5?
Yes, and I would recommend replacing the timing belt at the same time.
When replacing water pump on 95 contour 2.0l engine harmonic balancer seems to be in way cant get it off how do you do this?
Pull the retaining nut then use a puller to remove the harmonic balancer.
How do you take off crank shaft pulley on a 1995 Honda passport?
disconnect the battery, remove the bolt in the center of the pulley, then use a harmonic balancer tool to remove it
What is a dual wan load balancer?
A dual wan load balancer is a router. Uses state of art redundancy and bandwidth load technologies. It allows fast and secure internet connection. It makes sure all internet activity is always managed and secure.
How do you remove 327 harmonic balancer?
With a balancer puller tool. With a balancer puller tool.
Oil leak from harmonic balancer Chevrolet 350?
The oil leak is probably comming from the top of the oil pan there is a rubber gasket that goes between the oil pan and the water pumb which would make it look like its comming from the harmonic balancer, try replacing the oil pan gasket this should fix the problem. New answer: There is a small round oil seal / Harmonic balancer seal that fits in the timing cover and the balancer slides through the center of it. That is probley were your oil leak is. Most of the time the balancer itself gets a groove wore in it over time from that rubber seal running on it. You can repair the balancer by buying a Harmonic balancer repair sleeve/ speedy seal. Also replace the front timing cover seal.
How do you change the crank sensor on a 96 Chevy Corsica V-6?
there are 2 crank position sensors. first 1 is the 24x located behind harmonic balancer you will need to remove belt 15mm bolt from balancer and balancer pulley. 2 8mm bolts and 1 10mm bolt are behind the balancer 1 13mm bolt is located on from block which you must disconnect. the other is located on the back of block which is the 7x 1 and this is just a 10mm bolt. It will take some playing around to pull this 1 out but it will come out and goes in very easy. before chaning any1 of these disconnect battery. When putting harmonic back on make sure its lined up w/ key hold and that's it all the way on.
What would cause a harmonic balancer to shimmy on a 350 Chevy engine?
The balancer has a piece of rubber that holds it together, The balancer is made of two pieces with rubber in the middle, and the rubber is coming apart. REPLACE BALANCER. The Pulley that's bolted on the balancer may be bent or not on stright and flush on the balancer, That would make the balancer look like its wobbleing too.
