do you mean your camshaft seal? and if so how much is it leaking? a steady stream or slight seepage? if it's leaving drips on the ground have it looked at for sure. if not it depends on the age of the vehicle if you even want to look at it or not
no, the cam shaft is on the engine cylinder head..
The sensor on the CAM SHAFT!
this probably means you have a worn cam shaft or cam shaft or the arm that hits the cam shaft to open the valve is worn. this is internal on the engine.
Cam spins at half the speed of the engine.
cam chains are a chain the attach to the crankshaft and the cam shaft , the crankshaft is the shaft making the pistons go up and down the cam shaft makes the valves open and close, the crank shaft and cam shaft have to be aligned a certain way or the car will not fire, this is called "timing" . if your looking for where it is , its most likely in the front of the engine get a pro to look at it.
Does anyone know of any chevy beretta cam shaft problems?
No, if it is leaking it needs to be replaced and replace immediately. The reason being is that the Water Pump in your Accord is driven by the Cam belt and so is the Balance Shaft. They are all driven by the same belt. If the water pump fails it can break the cam belt. As your engine is an interference engine, you will have serious engine damage if the cam belt breaks which will cost plenty to repair. The cam belt should be replaced every 90,000 miles. Ignore this and you may pay dearly for that. If the pump is leaking, replace it, and the cam belt at the same time.
No Cam Shaft; therefore no Belt!
what torque specs on cam shaft bolts 2000 saturn 2.2
Depending on which end it's coming from, you probably have either a leaking tailshaft at the PTO gearbox, or a leaking input shaft seal on the hydraulic pump.
If you mean dripping out of the of the tranny where the shaft slips in then the leaking is it
what torque specs on cam shaft bolts 2000 saturn 2.2