Yes it is legal. My father rides a motorcycle I'm sure.
The headlight switch is faulty.
H7 for headlight. H7 for cornering lamp. H1 or H7 for main beam Hope this is of use to everyone.
Most Rover 75's use H7 for dipped beam and H1 for main beam headlights.
X - Type Oners Manual, page 96, ----- "a leaver, within the main beam headlight, is used to dippped beam adjustment for touring. This lever flattens the dipped beam to avoid dazzling oncoming drivers.Open the bonet and remove the round cover from the main beam headlight.Move the lever in the left-hand headlight DOWN and move the lever in the right-hand headlight UP, to flatten the beam for driving on the right side of the road.Remember to place the lever back in the original position when you return to country of origin.
get a set of stick on beam deflectors. these deflect the beam from left to right for European contries. to adjust the light them selves you cant you would have to get a pair of European headlights for that.
how main beam crack in ship
H1 Car bulbs are among the most popular types, generally used where the dipped beam and main headlight are separate bulbs. Most manufacturers have at least one vehicle using h1 bulb fittings.
beam
It is important to fix the main beam light failure. The main beam failure might be as result of the melting of the fuse.
bad ground in high beam switch
Check the main headlight fuse. Check the start button, it interrupts power to the headlights. If the high beam indicator and the gauge lights are out it could be this switch.
Headlight Dipped beam Bulb H7 Headlight Main beam Bulb H1 Requires lots of patience and time as vision and access is restricted. Open the cover of the headlight by undoing the clips. Detach the connector (wires) of the bulb. Then put your fingers inside to feel for the spring/clip which holds the bulb. You need to press the clip to release and then the bulb will come out. Good light and a small mirror will help to locate the clip. Replace the bulb, push back the clip to hold the bulb and push back the connector with the wires. Close and seal the unit properly otherwise you may get condensation and water inside the headlamps. This is for Headlight dipped beam bulb For the Main beam bulb , once you disconnect the connector (wire) of the bulb press and disengage the bars/clip to release the bulb. Replace the bulb and press to engage the bars/clip to hold the bulb and then continue as above.