answersLogoWhite

0


Best Answer

Generally a good practice to. For one, you'll have air in the system, and you'll want that out of there. Secondly, you'll want to make sure it can hold a vacuum... very easy to forget to tighten down a clamp, install an o-ring, etc.

User Avatar

Wiki User

8y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Is it necessary to pull vacuum on auto ac system if all components are changed?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why does your bronco stall?

# Idle speed incorrect # Fuel filter clogged and/or water and impurities in fuel system # Distributor components damp or damged # Fault in the fuel system or sensors # Faulty emissions system components # Faulty or incorrectly gapped spark plugs and/or wires # Vacuum leak at the carburetor/throttle body,intake manifold or vacuum hosses


Where do vacuum lines go?

from the vacuum source in the intake manifold,to various vacuum operated components


When recharging a refrigeration system with R-11 what vapor pressure is necessary in the shells before charging with liquid?

21.1" vacuum


What components has the transistor replaced?

Mainly vacuum tubes.


The very first electronic computer components?

Vacuum tubes.


Why would your car stall in reverse when you press on the gas a little?

Idle speed incorrect , fuel filter clogged , fault in fuel system , faulty emissions system components , faulty or incorrectly gapped spark plugs , vacuum leak at the thottle body , intake manifold or vacuum hoses


If an hfc-134a AC system still has pressure after the first refrigerant recovery process is complete additional recovery is necessary until the system vacuum level remains stable for?

5


Is a feather falling in a vacuum projectile motion?

A feather falling in a vacuum is not considered as a projectile motion. Gravity, which is absent in a vacuum, is one of the components of projectile motion.


Measuring a final system vacuum is done with the?

system isolated and the vacuum pump turned off.


Why wont your jeep axles lock?

guessing that you have one fo the central axle disconnect systems. the transfer case vacuum switch, and the vacuum actuator on the axle are both prone to failures, but easilly replaced. there are numerous aftermarket kits to convert to a manual, cable operated system, adn remove the vacuum components entirely.


What is the diesel vehicle have a vacuum pump?

Because a diesel engine does not create vacuum and the vacuum pump is necessary to operate things like the vacuum assist brakes and cruise control.


What is wrong with your car if you have changed wires sparkplugs and fuel filter but it is still missing real bad?

try changing the distributor cap , Faulty emissions system components , Low or uneven cylinder compression pressures , weak or faulty ignition system , ( Vacuum leaks at the throttle body, intake manifold or vacuum hoses . spark plugs incorrectly gapped ? check the spark plug cables..if they're not in a specific order on the distributor its gonna miss fire..check your owners manual to see the timings