0
Is it possible for a gate output to receive current from other sources?
Wiki User
∙ 13y ago
Yes. You can use an open collector design, and you simply need a pull-up resistor to make it work. You can also use a tri-state design, and you simply need to make sure that only one gate is turned on at a time. These techniques are useful in bus design, where there is more than one sender, but only one is turned on at a time.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Why input current of USis less than Output current?
Why input current of USis less than Output current?
What is current controlled current sources?
A unidirectional current controller device is a type of electrical on/off switch. In order for an item to work that is plugged into a particular outlet, the switch must be in the on position. It is like having lamps plugged into outlets that are controlled by only one switch.
What determines the output voltage and the current of a transformer?
The ratio of output windings to input windings determines the ratio of output voltage to input voltage. The ratio of current is the inverse.
What is current gain and voltage gain?
Current gain is the ratio of output current divided by input current. Voltage gain is the ratio of output voltage divided by input voltage. Nothing more complicated than that.
What is CT ratio?
CT ratio is the ratio of primary (input) current to secondary (output) current. A CT with a listed ratio of 4000:1 would provide 1A of output current, when the primary current was 4000A.
What is the difference between independent and dependent source?
Independent SourcesIndependent sources produce current/voltage at a particular rate that is dependent only on time. These sources may output a constant current/voltage, or they may output current/voltage that varies with time.Dependent SourcesDependent sources are current or voltage sources whose output value is based on time or another value from the circuit. A dependent source may be based on the voltage over a resistor for example, or even the current flowing through a given wire. The following sources are possible:Current-controlled current sourceCurrent-controlled voltage sourceVoltage-controlled current sourceVoltage-controlled voltage sourceDependent sources are useful for modelling transistors or vacuum tubes.
Why is output dc higher than input ac?
Output power can never be more than input power. With a transformer, it is possible to increase the output current (while decreasing the output voltage), or to decrease the output current (while increasing the output voltage).
What are two sources of dc output error voltages?
A: I imagine op amps. If that is the case there are two sources of output errors related to the input. One is that the input diode while conducting are not at the same potential due to miss match of the diodes the other is current offset due basically for the same reason miss match of current pathways.
What is saturation region in general?
Saturation region is one in which the output current is independent of the input and remains almost constant. Hence, MOSFETs in saturation are modeled as current sources( whose current is independent of voltage across it)
What is difference between output current and pulse current?
It is a language in electronics describing whether the output is a pulse or direct current for any output.
What happens to the power outputs of the sources if more lamps are connect in parallel?
Nothing will happen to the possible output power of the power source i.e it will not increase. Each power source has its maximum possible output power. Adding more lamps in parallel will result in a drop in the circuit's total resistance which causes the total current drawn by the lamps to increase. Your wires might be burnt as a result so be careful.
Why input current of USis less than Output current?
Why input current of USis less than Output current?
What if two current source connected in series?
Theoretically not allowed and practically not safe or desirable to have two current sources in series or two voltage sources in parallel. In practice, the sources will get hot and catch on fire -- very unwise to even try.
What is output short circuit current?
The output short circuit current is the solar cell's current when the voltage is zero, or when it, is short circuited.
How do you get your iPod Classic to output video?
MP4 Is the current output.
What is current controlled current sources?
A unidirectional current controller device is a type of electrical on/off switch. In order for an item to work that is plugged into a particular outlet, the switch must be in the on position. It is like having lamps plugged into outlets that are controlled by only one switch.
How did World War 2 affect the world economy?
US industrial output made it possible for all nations through out the world to receive US aid.
