I suppose so. If a three input NAND is used as a two input device, the third input can be viewed as an inhibit input.
Also some NAND devices can be "3 stated" where the output goes to a high impedance.
It is possible to inhibit the NAND gate by linking the two inputs together and then set it to logic state 1.
That title of "Universal Gate" is reserved for NAND gates because you can build all possible logic using only NAND logic . You can build even other basic logic like AND, OR and NOT using NAND.
A+b=
There are two forms of the NAND gate. Inverted input: Ouput = not Input1 and not Input2 and not Input3 ... Inverted output: Output = not (Input1 and Input2 and Input3 ...)
The NAND gate has two or more inputs, and one output. This output is the complement of the AND of all the bits and will only be 0 if all the inputs are 1.A NOT gate on the other hand has only 1 input, and the output is the complement of this input.So to make a NAND gate into a NOT gate, we should tie (short, connect to same value) all the inputs of the NAND gate. At the output we would have the complement of the signal given at the tied inputs.This way we have a NOT gate from a NAND gate.
Dr Nand Lal Sharma From BJP
the not gate applied to and gate is nand gate
Gyani Nand was born in 1943.
74ls00 is the ic no. Of nand gate
nand gate
Not And (electronic logic gate)
Four.
when the two inputs are shorted, a NAND gate acts like a NOT gate. hence AND = NAND + NOT For OR gate, inverse both the inputs before connecting them to a NAND gate. So three NAND gates would be needed.
Final answer will be NAND bz from first NAND ans NOT AND then Again NOT ( NOT AND) ans AND then Again NOT ( AND) so final ans will be NAND.
two nand gates
Lisa Francesca Nand was born in 1974.
Nand Lal Meena was born in 1946.
Gyani Nand died on 2007-07-23.