626
1995
Approximately 37
Look for the OBD II connector under the driver's side dash. It was required 1996 and up but some models had the connector before it was necessary.Answer96 and up According to the Chilton's manual, the 1995 Protege and Millenia are OBD-II, also 1994-1995 Mazda 626 with ATX transmissions are OBD-II, and then all models 96 and up...I have a 95 buick with OBD II, however it requires a different plug to work with a scanner. If you take the car to Autozone or Advance Auto Parts to have them scan it and it won't scan it could be the same reason mine won't. In 95 they were transitioning to the (then new) OBD II system, and some of the first OBD II harnesses only had 5 pins rather than the full (I believe 10 pins) found on the 96 and later OBD II harnesses.
change the cam position sensor
The fuel pump is located under the back seat. Pull up on the front of the back seat and you will see a cover plate with four screws. There is also a wire going through the middle of th plate.
Cars that start with the letter M include a Mustang. Also there is a Mercedes, or even a Mazda.
where is the brain on a 97 lincoln continental
The Mazda CX-9 has decent fuel efficiency for a crossover SUV. It has a comfortable interior and is reasonably priced. Th CX-9 is a fun SUV to drive and has a sporty look.
On the middle console in front of the gearstick undern the radio. If i remember correctly it should be the 4:th or 5:th button.
amys birthday is on the 18 th December 1994July 1
Check the wheel bearings and the front brakes for wear. These are the most common places that cause the roar.