0
Is the 1995 kia sportage hood headlight assembly blinker bumper compatiable with the 2001 kia sportage model?
Wiki User
∙ 16y ago
since i have both,the answer is no.headlights are different,hood will probably be ok.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you replace front blinker bulb on a 2000 Buick LeSabre?
There is a long bolt on top of the headlight/blinker assembly. Remove this bolt and slide the entire headlight/blinker assembly out just enough that you can see the bulb socket. Twist the socket and it will pop right out.
How do you change a front blinker on a 2000 Pontiac Montana?
The headlight assembly has 3 screws that need removed. After removing the screws, then remove the headlight. The turn signal is located in the side light assembly. The blinker or turn signal assebly will pull forward and come out. After pulling it forward you can unsnap the wire and turn the blinker bulb, loosening it, then remove and replace. Be careful replacing the blinker assembly. There is a small part that "snaps" together when it is installed properly. If you do not install properly it will be O.K. but will not be lined up correctly.
Why is the headlight and blinker not working on a 1997 Nissan altima?
One headlight not working
How do you change the headlight on an infiniti G20?
You have to disconnect the whole headlight assembly with the headlight attached. Remove all the bolts from the assembly and pull it out with the headlight attached.You may have to move things out of your way,like the corner blinker light and plastic trim. When you get the assembly out with the headlight attached,there are 3 black plastic retainer clips holding the headlight to the assembly. Push the tabs on the sides of the retainer clips to release them then pull them out. The headlight then comes out,don't damage or lose the retainer clips,they are almost impossible to find cause they must only come with a new headlamp or assembly because I needed some and noone had any, not even Infiniti dealer. I had to go through many Nissan's at the salvages to find some.
Where is the headlight switch in your Kia Sephia?
on my blinker turn signal
How do a change front blinker on a 2003 dodge ram 1500?
1. Take the three bolts that hold the headlight/ blinker lens assembly off. 2. Pull kind of hard straight out. There is a clip that should release. If it does not realease then break it. 3. Change bulb.
How do you remove side marker light assembly on an Oldsmobile silhouette?
On my 99 you remove the headlight assembly by removing the two plastic covered wing nuts, then remove the side marker/blinker assembly by removing the plastic covered wing bolt, then the light is accessible. It sounds harder than it is!
How do you replace the headlight modules?
i have a 2002 Chevy trailblazer. im trying to switch out my blinker light and i was told i need to take my light assembly out. how do i do this. i took off the grill and im stuck from there. can you help.
How do you change the passenger side blinker bulb on a 1999 Chevy Cavalier?
Get under the car reach behind the bumper reach towards the blinker then find the wire that goes to it. Then twist the end left and pull out the light bulb in and and replace. For the headlight blinker you have to unscrew the headlight with either a 10 or 13mm socket...pull it out...then twist the end that goes into the blinker left...replace bulb....put things back together....done.
How do you change the headlight assembly on a 1995 ford escort lx?
Headlight Assembly 1995 Ford EscortI did just that today. The side blinker lights have 2 screws (One you have to open the hood to reach and one that is on the lower bottom corner towards the tires) that need to be taken out, take off the decorative grill (screw under hood, dead center and four plastic holders on each side of the grill {twist to remove [I think} because mine were broken}) there are 2 bolts on each side of the headlight assembly and one on top. Easy peasy, even a girl (ME!!) can do it. I used a 10mm socket for most of it and a Phillips heas screwdriver for the blinker lights. Now I just need to figure out where all of the adjusting screws are and how they work.
How do you remove the front blinker cover on a 2003 Chevy Express van in order to replace the blinker?
You remove the headlight to gain access to the back of the blinker housing, you can reach into the back of it and pull out the light and cable it's attached to. It's a pain.
How do you get headlight switch off blinker stalk off Mazda 626 1997?
may be you get a replacment stalk?
