answersLogoWhite

0

There are several Chrysler engines built for 2004.

They are all better than average for durability and reliability in comparison to north American, Japanese and European equipment of the same displacement.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

Is a 5.9 a good motor?

Chrysler V8, yes. Cummins diesel, yes.


What can a Chrysler 2.7 liter motor fit in?

With knowledge,tools and desire the answer is anything, I once saw a 283 Chevrolet engine installed on a modified snow blower, it did a good job with the snow.


Is the 2.7 Chrysler an interference motor?

I am replacing one right now because it most certainly IS an interference motor. Good luck!


Is a 327 motor good?

Yes it was a real good engine, and still is.


If the Blower motor doesnt work and switch motor relay and fuse are good what could be the problem on an 2005 chrysler town and country?

Resistor or blower motor power module.


Where is the starter located on 2002 Chrysler Sebring?

I'm looking up this site to see how to get the starter out. It is located in front center of the engine above the front motor mount. You can see it from under the car looking up between the front catalytic converter and the engine block. Good luck getting to it.


In trucks what is a LU3 engine?

That is the Vortec 4.6L motor by GM. Good motor, built off of the 5.7L technology.


Where is the wiper motor on a 1991 Chrysler Lebaron convertible 3.0?

The wiper motor should be located on the driver side under the cowl grill below the wiper blade good luck


Why do the turn signals not work in a 2004 Chrysler Sebring?

If the bulbs and fuse are good, replace the turn signal Flasher Relay.


What is the horsepower and torque of a Chrysler 2015 pentastar v6 engine?

The 2015 Chrysler Pentastar V6 engine produces approximately 283 horsepower and 260 lb-ft of torque. This engine is known for its balance of power and efficiency, commonly used in various Chrysler, Dodge, and Jeep vehicles. Its design emphasizes performance while maintaining good fuel economy.


Is the N14 cummins a good motor?

Very good engine, although replacement parts are getting harder to come by.


Is 1.2 Engine Size good?

it depends on what you want it to do, its a small motor so it probably get good mpg but that's about it