Want this question answered?
diagram oil injection system xlt 1200
Check your gearbox level you have an oil leak in your oil injection system or your gear box. The injection oil is lighter than the the gear box.
If operating the engine without the oil injection system, supplied with the engine, use a 50:1 ratio. When using the oil injection system, no additional oil is required.
You've got a leak in your fuel injection system.
Many Polaris 2-stroke motors have an oil injection system that varies the amount of oil required. If a user is eliminating this system, or has a unit without oil injection, the standard ratio is 50:1.
That would depend, in large part, on why it was disconnected in the first place. Whether or not to run the oil injection system, rather than mixing the oil directly with the fuel, is a question of personal preference. Some boaters like the convienence of oil injection, while others prefer to mix the oil themselves. At any rate, if you choose to reconnect the injection system, make sure the system is delivering the proper amount of oil to the engine.
If not using the oem oil injection system, use a 50:1 ratio, one pint of 2 cycle oil, to six gallons of fuel. If operating with the oil injection system, supplied with the engine, no additional oil is required.
a two-cycle engine derives all of its lubrication from the pre-mix oil that is mixed with the gasoline. this is done either in the raw fuel or via an oil injection system. if you have an oil injection system there is nothing wrong with putting straight gas into the tank as long as the oil reservoir contains a lubricant designed for an oil injection system. however if you do not have a oil injection system putting straight gasoline into the engine will more than likey cause the engine to lose lubrication and either rapidly wear down any internal components or in the worst case seize the engine solid
The fuel oil ratio for a 140 hp Mariner outboard motor is 50:1. Mariner is a brand of the Mercury Marine company.
i believe they have an oil injection system on these engines
You don't. You can remove pump and pre-mix the gas.
The correct mixture would be 50:1, roughly one pint of 2 cycle oil to six gallons of fuel. This is provided the engine is not equipped with, and or using the vro injection system. If your oil injection system is operational simply top off your oil reservoir, no additional oil is required.