Yes, the whirlpool setting is simply a setting that pumps water, but bypasses the filtration system hence increasing flow volume.
WHEN YOU SELECT RECIRCULATE THE HUMIDITY LEVEL CAN INCREASE SIGNIFICANTLY IN THE CAR SO THE A/C IS TURNED ON TO DE-HUMIDIFY THE AIR, JUST SELECT A WARMER SETTING TO MAKE IT COMFORTABLE.
If you're talking about your pool filter, it should be set to filter or run. Use the bypass or recirculate setting if you wish to circulate the water without having the water pass through the filter. Use the backwash setting to clean the filter.
This setting inhibits the vehicle from collecting all of its intake air from the outside, similar to a 'recirculate' button, so that the A/C does not have to keep drying the salon air.
Going to need more specifics here. How many jets do work? Are your valves in front of the pump turned on? What setting is the filter on? Try turning the filter to recirculate/bypass/whirlpool to bypass the sand and eliminate sand problems as a possibility. Does the pump come on and hum or does it spin full speed? Is there air in the lines? Is the pump pot priming all the way?
If you have a sand or DE filter the setting is filter in the case of cartridge filters it is filter as always unless there are other settings for your particular setup.
You have the system set to allow outside air to circulate into the vehicle. You can change this to the recirculate mode which will only circulate inside air. Look for the button to change the setting.
There are a number of possible ways in which one can go about bypassing internet filters. These include de-filter sites, setting up a new proxy or using a program called Ultrasurf, which can be accessed online.
Need more specific info A multi valve pool filter is a common configuration of valve and filter for a swimming pool system. The piping into and out of the filter is attached to a multivale. A multivalve has has several positions. One type of multi valve has six positions: backwash, waste, filter, closed, rinse and recirculate. (These valve positions are used on a DE filter. A sand filter may be different.) Use the filter setting in the nromal operation of your pool. This setting receives water from the pump and directs it to the dirty side of the filter media and then receives weater from the clean side and directs it to the pool. Use the Backwash setting to flush the DE from the filter and to a drain. Use the waste setting to flush water directly from the pump to the drain. The closed position is, well, closed. Rinse? Recirculate?
Hit the recirculate air button.
One way if you have a sand filters is to use it's waste setting. That directs the flow of water out the backwash line without filtering it.
Spam filers can be set up to prevent unwanted messages and adverts being displayed on your computers. Spam filters can be set up by your ISP or on your OS.
lol....the fluid is water dripping from the lines and compressor of the a/c system and if your getting a fog from the vents change your a/c control setting from recirculate to fresh air intake.