0
it is located in the distributor under the metal cap.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Will a 3.0 SOHC motor from a 1994 Chrysler lebaron fit a 1993 3.0 SOHC dodge stealth?
No.
Where is the crank position sensor on a 1992 Dodge Stealth?
on the 4G63 it runs off the cam-shaft. otherwise, it is behind the crankshaft pulley, an inductive bell and strobe setup. The previious answer is true, but the 92 Dodge Stealth came with 3 engine options. The Base Model came with a SOHC 6G72, The ES and RT with a DOHC 6G72 and the RT/TT with a Twin Turbo DOHC 6G72. In answer to te question in 92 the crank sensor is run off the camshaft similar to the 4G63. It is located on the intake camshaft, of the rear head on the transmission or rear of the block
Where can you buy a cheap ecu for your sohc dodge stealth?
I just purchased a used one off a '96 SOHC for $25.00 + $9.00 S/H look on eBay under eBay Automotive.......Dodge Stealth and Mitsubishi 3000. Happy Huntin'.
You are rebuilding your 91 dodge stealth sohc engine and you need to know the gap between the crank and the bearings it is now over 3000 of a mm whats the right gap?
.015 to.02 / check with plasta gage
How do you change your 91 dodge stealth SOHC non turbo to a turbo?
by putting a turbo engine into it.....non turbo engines were not meant to handle boost especially sohc engines...you can try to supercharge it though...there are many kits out there just for sohc stealth and 3000 gts
Can you replace a 1993 dodge stealth base model 3.0L SOHC motor with a 1995 Chrysler Lebaron 3.0L sohc motor by changing the intake?
No, they are not the same.
What is the axle bolt size of a fwd dodge stealth non turbo sohc?
It is a 33mm socket you will me to remove the nut
What is the yellow light in the corner above my low antifreeze light on my 1995 dodge stealth SOHC?
low washer fluid
How do you change your 1993 dodge stealth sohc non turbo to a turbo?
a lot of time and money, or a mechanic is handy too
How many O2 sensors on a 91 dodge stealth sohc?
Should be Two to Three, One on Each Header and then on before the CAT.
How do you replace the water pump on a 1991 Dodge Stealth 12v V6 sohc?
Please see "related questions" link at lower left.
Where is the IAT sensor on a 98 dodge neon.?
If it is a SOHC it is on the air take between 1st and 2nd port
