I can't say if there is a difference, but I will tell you this... Use the harness off your old engine, ya know, the one that came with the vehicle. I learned this lesson the hard way.
yes there is!!
This is not really an answer,but I have a problem with a wiring harness on my 93 caravan also. I have not gotten to the point of solving the problem, but was wondering if you got your problem solved and if you found a diagram and where did you get your wiring harness? Another searcher!!!!
88 is speed density 91 is the mass air system 89-93 all 5.0 mass air
Replace the wiring harness. Easy fix. Most likely is a broken wire.
yes.different plugs on several sensors and the plugs going into the pdc and ecu.
On the Safari's, the wiring harness in between the door and the body become brittle with usage.....therefore when it rains, moisture gets in the boot-sleeve where the wiring harness sits in. Check all wiring for discolouration or torn wires. On the Safari's, the wiring harness in between the door and the body become brittle with usage.....therefore when it rains, moisture gets in the boot-sleeve where the wiring harness sits in. Check all wiring for discolouration or torn wires.
The front blower resistor on a 98 Dodge Caravan is replaced by removing the cover and disconnecting the wiring harness. The resistor can then be pulled and a new one put in its place.
Yes and no, you'll need to replace the computer,trans,motor mounts,front exhaust pipe and possibly the wiring harness, not a job for the inexperienced
There is a wiring harness most everywhere you look on that and any vehicle. Be more specific.
If the question is refering to the wiring harness that comes with a Grand Caravan with the optional towing package. The harness comes in a plastic bag somewhere in the interior of the vehicle but is not installed. The harness is installed by removing the rear bumper cover and tail light assemblies unplugging the lights from their respective harnesses and installing the harness between the light and connector that was just unplugged. The harness is simply routed out below the light assemblies under the bumper cover and out near the hitch receiver. Replace light assemblies and bumper cover and the installation is complete. The hardest part is stuffing the new harness connectors back in the body panel with the included padding to reduce noise from the connectors bumping against the body panel. The whole process can be completed in about 45 minutes.
The 2000 Dodge Caravan alternator can be changed by removing the alternator belt. Remove the wiring harness from the back of the alternator. Loosen and remove the alternator retaining bolts. Install the new alternator by reversing the process.
The error code p1193 on a 2001 Dodge Grand Caravan indicates that the intake air temperature sensor has failed. The sensor can be replaced by unbolting it, removing the wiring harness, and pulling it from the intake.