answersLogoWhite

0


Best Answer

The flasher for the turn signal and hazzard lights is internal to the hazzard light push button. A very bad design choice, because the entire dash bezel needs removed to remove the switch. But that is only 6 screws and a couple of clips.

Before buying the dealer only part. Take the switch out and give it a tap on a solid surface. That fixed mine. 10 minutes of work and it was fixed.

I have been without my right turn signal unless I flop it with my hand... I have surfed the net and noticed a ton of similar problems requiring the entire multi swith turn signal. I am thinking we should all try for a recall of some sort. My car should not have this problem. It is a 2000 Chevy impala and in great shape with 94,000 miles.

User Avatar

Wiki User

โˆ™ 2011-09-13 05:45:55
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: Is there a fuse for the turn signal flasher unit on a 2001 Chevy Impala or do you have to replace the entire part ACDelco 150?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the 4 way flasher on 2002 impala?

The flasher unit is contained inside the hazard light swith on the dash. You need to remove the dash panel and pull the switch out from behind. The entire switch must be replaced which is about - at a Chevy dealer.


How do you replace the flasher in buick park avenue 1998?

Cost $700 in labor to replace the flasher as the dealer could not locate it. Supposedly the entire dash had to be removed on my 1997 Park Ave..


How do you replace a flasher on a 91 Toyota Previa?

Tail lights are replaced by removing the entire rear plasic cover to the back hatch.


Where is the turn signal flasher for a 2000 Pontiac Grand Am GT?

On my 2001 it is part of the Hazard switch. You have to replace the entire switch on a 2001.


Where is the hazard flasher in Chevy Venture 1998?

It is built into the multifunction switch which controls your signals,high beams,cruise,etc...have to replace entire unit.


Where does the signal flasher go on a 1987 Toyota Celica?

Near the fuse box inside the cab, driver side kick panel (left side), next to clutch for manual - next brake for autos. It should be a three plug flasher. On mine, the housing where the flasher goes is blue. I took out the entire harness to remove and replace.


How do you replace the right bedside of a pickup truck?

You replace the entire thing


Do you replace the entire headlight or bulb when the headlight is out?

On older vehicles you replace the entire headlight. On the newer vehicles you just replace the bulb unless the headlight assembly is damaged.


How do you replace the speedometer in a 95 Honda Accord?

You have to replace the entire instrument cluster.


Where is Electronic flasher 94 cougar?

If your referring to the emergency flashers.... it'snactually in the turn signal switch. i have a 94 mercury cougar xr7 and when i bought it the emergency flashers did not work. i in the end i had to replace the entire turn signal switch in the steering column.


Whereis the location of a flasher on 99 olds cutlass?

The flasher is made as part of the hazard switch on the dash. It must be purchased from GM, not a parts house because they still list standard flashers for this model. Remove the center air vent above the radio and two small bolts attach it on the left. Replace entire switch unit. It cost me about 25.00


How do you replace radio lights on a 1998 Monte Carlo?

Cant you have to replace the entire radio

People also asked