Try changing the bulb that doesn't have the low beam. Check at your local auto parts store for the correct bulb.
The problem is probably in the mixing door not operating properly. It could be in the control panel or the door itself. It just has to be checked out. GoodluckJoe----------------------------------------------------------------------; Blend Door Actuator
On a 2003 Ford Expedition : There is an ABS warning light to the left and slightly lower than the " E " on the fuel gauge , which you should be able to see when the ignition key is turned to the RUN position , just before starting the vehicle ( to prove that the bulb still works ) so it looks like a 2003 Ford Expedition does have an Anti-lock Brake System
the ac only works on high the AC blower motor resister is located behind the pass. side kick panel's. just ahead of the door. this only applies to Eddie Bauer's. all others are on the side of the blower motor housing behind glove comportment Eddie Bauer us a solid state type 2"x2"x1" box. if the AC only blows on high the most likely casuse is an open inside the restior.
Have you checked the bulb , it has 2 filaments in it , see if one of the wires is broken
Try it in the ignition and see if it works. I sold my 1993, but I am pretty sure it cannot.
check the ground wire to that headlight .
The most likely answer is that he disconnected a wire that he did not reconnect. You should take it back to the shop and let him reconnect it. He will know exactly where that wire is because he has done it many times.
Headlight wash wipe normally works when the headlights are on and you press the screenwash button
#9006.
Some motorcycles have a separate switch for the headlight that works independently of the ignition. If this is not the case, then there might be a short in the wiring for the headlight.
I have one signed lower left by Harlow and lower right by Bauer. So I guess that is a yes.
The Cases of Eddie Drake - 1952 Shoot the Works - 1.7 was released on: USA: 10 April 1952