0
Is there a law against returning or exchanging unworn swimwear in NY State?
Wiki User
∙ 12y ago
as long as youdont remove that protective that in the private part you can return a
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What sentence can you use for unworn?
My jeans were really unworn.
How much can you get for unworn clothes?
It depends how much you spent on the clothes.
What is the return policy when buying bra tops at Walmart?
The return policy for bra tops at Walmart only applies if the clothing is unworn, and the tickets are attached and accompanied by the original receipt. The owner has 90 days to return the unworn item back to any Walmart.
What is the weight of a twenty dollar gold coin?
The standard weight is 33.4 gm for an unworn $20 coin issued from 1849 to 1932.
How much silver does a Morgan silver dollar contain?
An unworn Morgan weighs 26.7 gm and it's made of 90% silver.
What is foot lockers return policy?
refund or exchange on unworn items with a receipt. without one you can get a gift card for the current selling price.
How much does a pre 1964 quarter weigh?
In unworn condition, 6.25 gm. Current copper-nickel quarters weigh 5.67 gm.
What would cause a 2006 Ford F-150 make a grinding noise when step on the throttle?
a close and unworn drivetrain or not enough grease in the bearings
What is the value of an 1801 dime?
These are extremely rare as they only made 34,640 of them. A well worn sample could still bring $300-$400, and a relatively unworn one into the multiple thousands.
How much does an 1898 Barber half dollar weigh?
Barber halves (as well as Walking Liberty, Franklin, and 1964 JFK halves) weigh 12.5 gm when unworn and are composed of 90% silver, 10% copper.
How much pure silver does a Morgan dollar contain?
90% silver, 10% copper An unworn Morgan dollar weighs 26.7 gm so it contains just a bit less than 25 gm of pure silver.
What is cylinder ridge?
In a internal combustion engine, a cylinder ridge is an unworn area around the top of the cylinder wall. In that engine, the piston moves up and down in the cylinder, and the rings seal the piston in that cylinder. But the rings are spaced "down a bit" from the top of the piston. And when the piston reaches top dead center in the cylinder, the rings haven't gone all they way to the top of the cylinder. They end up wearing the cylinder out "underneath" that top area. In other words, it's the top part of the cylinder that is not in contact with the piston rings. It's the "unworn" part, if you will.
