If there is a second blower motor and speed control for the rear air, then there is also a second Resistor Pack. It will be located near the rear blower motor. Exactly I cannot say. Follow the wiring.
When the fan is on high it does not run through the blower motor resistor. The low speeds don't work because the blower motor resistor is bad.
On the auto temp system that happens when the blower motor resistor fails. It is behind the glove box.
A blower resistor can be replaced, in your 2002 Oldsmobile, by removing the resistor wiring. Remove the retaining screws. Reverse the process to install the new resistor.
To change the blower motor resistor in a 2002 Nissan Maxima, locate the blower motor resistor under the glove compartment on the passenger side of the vehicle. There is a clip that is depressed and then the resistor will slide out. Remove both ends of the resistor and then replace with the new resistor.
Generally the blower motor resistor is found close to the blower motor. It relies on the blower motor to keep it cool.
how to replace blower resister on a 325i BMW 2002
It should be called the auto HVAC blower motor resistor wire harness. Goes from the auto climate blower motor resistor to the blower motor.
sounds like a bad blower motor resistor and or plug
It's right behind your glove box. My kids replaced it. Remove the glove box. It's easy to unplug and plug in the new one. Approx $80- 100 from your Chrysler dealer. ( If it fails your blower works on its default with fan at full speed and not adjustable ) That is the front blower motor resistor which is located behind the glove box; the rear blower motor resistor (for cars equipped with the rear blower switch) the resistor is located below the final rear passenger window, to the right of the bench. In order to gain access to it you will need to remove the bench and a few trim pieces.
The blower resistor is located under the dash, near the floor, on the passenger side of the vehicle. I had to replace the resistor about a year ago. It is not an easy place to work in. You have to remove the blower unit in order to get at the resistor. Not fun, but rewarding when you actually do it yourself.
where is the blower motor resistor located on 2002 gmc envoy?
It is on the evaporator case and is held in with 2 screws.