Just take your fingers and turn the rubber boots left and right a few times , then grab
them real tight and pull it off the spark plug. Sometimes there tough to pull off, but they will come off.
Disconnect the battery, remove the spark plugs wires and boots and remove the spark plugs. Put in the spark plugs, replace the spark plug wires and boots, and connect the battery.
There are no spark plug wires, this is a coil on plug system. The spark plugs are under the coils that bolt to the middle of the valve covers.There are no spark plug wires, this is a coil on plug system. The spark plugs are under the coils that bolt to the middle of the valve covers.
Pull the spark plug wires off the spark plugs. Remove the spark plugs with a spark plug socket. Install the new spark plugs and put the spark plug wires back on. I recomend replacing the spark plug wires as well. If replacing them, just remember that the new wires are hooked up the same ways that the old ones came off.
Disconnect the battery, remove the spark plug wires and boots, and remove the old spark plugs. Toss out the old spark plugs, put in the new spark plugs, replace the spark plug wires and boots, and connect the battery.
Pull on the boot.
No you do not need to replace any plugs at all when replacing wires.
Spark plugs wires are just wires that happen to go to spark plugs. They weren't really "invented", it was more or less obvious once the spark plug was developed that there needed to be some way to get electricity to them.
No spark from coil, bad plug wires, or bad plugs.
Remove the spark plug wires from the spark plugs, use an extension for your Allen wrench, and use a spark plug socket to remove the spark plug.
Disconnect the battery, remove the spark plug wires and covers, and remove the old spark plugs. Next, put in the new spark plugs, attach the covers and spark plug wires and reconnect the battery.
The wires running from the coil to the spark plugs are the leads.
They are located at the end of the spark plug wires.