The best way to bleed air in any car's cooling system is to elevate the front of car so rad cap is the highest point of vehicle. Then just simply leave cap off while motor idles. Add coolant as necessary over the course of 30 minutes.
where can you find a diagram of 1994 pontiac grand am motor?
where is the location wiper motor Pontiac grand prix 2002
Where is the motor mount located on 1995 grand am
The bleeder screw for the coolant system is on top of the motor, tword right side of the intake manifold. It should look like a nut with a flat head screw in it on a piece that goes into the motor.
According to the Haynes Manual it's located in the Water pump cover.
no way dif motor monts
yes it should bolt right up as well as the original motor and tranny
Banda del motor
in the motor
It has 3
when it is cold take the cap off the radiator and start the car and let the air out The above answer is incorrect. The cooling system on the Grand Am requires you to bleed the system. There is a bleeder screw on the top of the motor, just follow the black tubing and you'll see it.
were is the crankshaft sensor located on a 1987 Pontiac Grand AM with a 2.5L engine
Could be,Low on coolant,A stuck closed faulty thermostat,A faulty cooling fan motor/system,
How to reset the computer 1999 pontiac grand prix gt 3800 series II v6?
The 1993 Pontiac Grand Am for cylinder engine has four motor mounts. There is a motor mount on each corner of the engine.
Depends on what motor you have.
My grandson had to replace the motor mounts on his Pontiac Grand Prix last year and now the mechanic says they need replaced again. He has hardly driven it. How can that be
yes as long as the grand am is a 2.4 twin cam also
there isn't a crankshaft position sensor on a 3.8l motor in a 1999 Pontiac grand prix according to the manual
More than likely as long as it has the same motor?
trying to locate ,the resister to the blower motor foe 2003 grand prix gt
Buy a car with a bigger motor