0
Is there a way to keep fog lights on when brights are on in a 1994 Chrysler Lhs?
Wiki User
∙ 10y ago
Not without rewiring the lighting system.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Why does a fuse keep blowing in a 1994 Chrysler New Yorker?
The circuit is overloaded or shorted to ground.
Why won't the fog lights on a 1997 Catera go on fuses are OK?
I have a 98 Catera and if the brights are on the fog lights will not turn on. I currently have a problem with getting them to come on at all. There was a squealing sound coming from the relay switch under the dash when I turned them on. I replaced the relay and the squealing stopped but still no lights. I gave up. Now one of the brights is out and I'm afraid to fix it because I have the headlamp housing rigged with foam and tape to keep the lights alined since the ajusting has broke off. It's a real shame about these cars.
What would cause the fuse for the tail lights and dash to keep blowing in a 1994 Ford Explorer?
A short in the wiring.
My 1994 Chrysler lebaron door locks keep opening and closing while driving?
Make sure you lock all of the doors and hope for the best.
What could be wrong with a 1994 Ford Explorer that wont turn on and the headlights keep flashing?
The flashing lights are probably the factory alarm.
When was Keep the Lights On created?
Keep the Lights On was created in 2012.
When approaching a car at night you should put your eyes where?
Keep your eyes on the road. If their brights are on and you can't see, keep your eyes on the white line on the right side of the road to help guide you until they pass.
Will too much oil keep 1994 Chrysler lhs from starting?
no but too much oil is as bad as not enough just place an oil change on the vehicle and use reccomended quarts If they have way too much, then it could keep it from turning over.
Do you keep it in overdrive on in a 1997 chrysler sebring?
YesYes
How do you replace flip up lights?
Turn the lights on then disconnect the battery. This well keep the lights in the up position.
How do you prevent being blinded by oncoming traffic?
You should slow down and focus on the white line on the right hand side of your lane. This will help keep you from being blinded, at the same time allow you to stay on the road by following the white line. If you believe the oncoming driver has his brights on, you may want to flash your lights OFF and ON once or twice to remind him to dim his lights. DO NOT flash your bright lights at the oncoming driver. The only thing worse than one blinded driver is two blinded drivers approaching each other head on.
What is the best way to keep the chrome on a Chrysler 300 shiny?
The best way to keep the chrome on a Chrysler 300 shiny is to buy chrome kits. With chrome kits, the chrome will always stuck to the Chrysler 300 shiny. A place that might sell chrome kits is Walmart.
