yes tun the key from off to ignitiont that's just before it starts the engine 3 times then look at the odomiter it will give you codes
You need to have the trans computer checked for codes. There will be a code that will lead to what is causing the no shift.
CAR WONT START Transmission may not shift. Check engine light could be on.
Check the clutch plate or have it checked.
You need to have the engine and trans checked for codes. The trans computer defaults to 2nd gear when it detects a problem and sets a code. You could have anything from a sensor failure to a major internal failure.
It is located inside the transmission, on top of the valve body. Remove trans oil pan, drop the valve body and the shift/control soleniod is on the body.
Check for a blown brake light fuse. Check for a broken or out of adjustment brake light switch.
Transmission is in limp mode and most likely it is the input or output sensor or a wiring problem to one of them.
More than likely, its your input and output speed sensor, If your speedo does not work, I can guarantee that is your problem..
Yes it will... you need to switch the flywheels though to mount it to the automatic transmission...
Normally just letting the computer shift for you is faster.
If the problem is that the shifter will not move you need to check the shift cable. If the shifter moves, but the trans doesn't shift; you need to check the fluid level and , the system for trouble codes.
If they are Automatics it will not shift properly. It would bolt up if they are the same engine.