Is there a wiring diagram for a 2 battery silver bomber scooter?

Answer 1

Silver Bomber wiring not difficult. I don't have a "factory" wiring schematic, but the Silver Bomber is not a very complicated electrical device. To wit: Two 12V batteries are controlled by the right handlebar two position "switch" electrically connected to the motor via a circuit board located under the "scooter board" on the right side toward the front. If the circuit board is faulty it may be very difficult to trouble shoot the board without electrical knowledge and testing equipment. Position one on the handlebar switch uses 12V from the battery positioned farthest to the rear of the Silver Bomber and sends 12V through the circuit board to the motor. Position two on the handlebar switch uses both batteries, in series, and sends 24V through the circuit board to the motor. There are two relays mounted on the right side to the rear of the circuit board. The relays are configured to direct the current from the two batteries/controlled by the circuit board. The wires from the circuit board are Red and Yellow +V, Green key circuit, and Black -V. Best way to trace wires is to use Volt/Ohm meter. There are only two wires to the motor Red + and Black -. Use the meter and tag wires and you will have a workable schematic. Good luck,