Want this question answered?
On the back of the engine, mounted between the engine and transmission, inside the bell housing. You cannot see the flywheel. The starter is connected to the flywheel when you start the engine.On the back of the engine, mounted between the engine and transmission, inside the bell housing. You cannot see the flywheel. The starter is connected to the flywheel when you start the engine.
you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points,
will 4.6 windsor engine with 6 bolt flywheel interchange with 8 bolt flywheel
No, a rusted flywheel will not cause the engine not to turn over.
Vitara g16a auto. manual box bolts up but flywheel bolt pattern is different Samurai g13b box bolts up but flywheel bolt pattern is different
In most cases the flywheel is bolted straight on to the end of the crankshaft.
Flywheels are fitted by engine and crankshaft pattern. Not bell housing diameter
A bad flywheel can definitely cause the engine not to turn over. The flywheel has teeth. If the teeth are chipped or broken, then the starter can not engage to spin the engine over.
no
take the tranny out and the flywheel is right on back of the engine, unbolt the flywheel and take it off and install new flywheel with new bolts and torque them down.
Crankshaft directly connects to the flywheel.
No. It positions the flywheel in the proper place for the ignition timing.