Flow rate cannot be converted into pressure units. So, you should give up the idea.
barometric pressure.
Hydraulics are typically measured in pounds per square inch, which is a measurement of pressure, or force exerted with respect to area. To calculate the force used, multiply the pressure measurement by the area measurement in inches. This will give you the force in pounds, then convert that to tons.
They do not compare. Inches of water is a pressure measurement, GPM is a flow measurement.
Micrometer is having a ratchet to rotate which is pre-loaded to get standard thrust while measurement, whereas in the case of a vernier the accuracy of measurement depend on the pressure each individual applying while the measurement.
Pa is the metric unit for pressure, Pascal. It is one Newton per square meter. Atmospheric pressure is approximately 101 kPa (101 000 Pa), which is 14.7 psi (pounds per square inch) in Imperial units. The air pressure in car tires is usually about twice that (32 psi, 220 kPa).
Blood pressure measurements are a combination of the systolic and diastolic pressure. Ideally, blood pressure should be under 120 in the systolic measurement and 80 in the diastolic measurement, commonly notated as 120 over 80.
Systolic and Diastolic pressure measurements are taken. Systolic is the higher pressure measurement, when the heart ventricles are contracted, and Diastolic is the lower pressure when the ventricles are filling. So if somebody's blood pressure is 120/80, then 120 is the systolic pressure and 80 is the diastolic pressure
football field measurementscooking measurementsnutrition measurementsmedical and health measurements (pressure, cholesterol, ... etc)material measurements (length, area, mass, density, volume, ...)Refer to links below for references
Robert H. Harvey has written: 'Bottom current and pressure measurements from the central equatorial Pacific' -- subject(s): Measurement, Ocean currents, Oceanography, Pressure
Millibars (mb.) you can use that measurement to measure Air Pressure. The NWS uses mbs to measure the air pressure inside a hurricane.
A compound gauge is a pressure gauge that displays both negative and positive gauge pressure measurements. Gauge pressure is a measurement of pressure relative to ambient pressure. For example, if ambient pressure was 14.7 PSI and you were to measure absolute vaccum using a compound gauge, the gauge would indicate -14.7 PSI.
A blood pressure measures the amount of pressure on your arteries when your heart is pumping and contracting blood. There are two measurements. One is the diastolic. The diastolic is the measurement of the pressure on your arteries when your heart is relaxed. This number should be low, in between 50 and 90. It is the bottom number in the ratio. The systolic measurement is the top number in the ratio. The systolic measurement is the amount of pressure on the arteries when the heart is beating or contracted. This number should be between 100 and 150. The text book normal blood pressure is 120/80=S/D. hope that helps.
Voltage- the measurement of electrical 'pressure'.
International Chemists us the SI system. the standard measurements are as follows temp-kelvin length-cm energy-joules time - seconds mass- gram pressure-atm
the non-invasive measurement of the pressure exerted by the circulating blood on the walls of the body's arteries.
The abbreviation for pressure is p
Dieter Emter has written: 'Underground measurements at tidal sensitivity with a long baseline differential fluid pressure tiltmeter' -- subject(s): Tides, Tide-gages, Measurement