Check the ignition coil for power. Check the crank position sensor, and make sure that the engine is turning over ( timing belt not broken.) Check to make sure that fuel is getting to the engine as well.
There are a number of reasons why 4x4 will notÊbe activated on your Isuzu Rodeo. This is mainly due to a wiring problem or a disconnect with the solenoid. You should ensure that a professional mechanic resolves the problem.Ê
No it wont work, the 96-97 Isuzu rodeo switches look similar to te 98-02 models but there's a difference.Also used 98 window switches cost more than 96-97 switches. http//:jlkautoparts.com
had same prob with my 96. Take window fuse out and put it back in. It is like a breaker. You probably overloaded it.. Worked for me. Should reset.
my 2000 nissan altima wont start has new radiator and spark plugs the computer test shows no problems it recently overheated
is the glow lamp on when you try to start , if not it could be the the glow plug fuse or relay , you could try a very small squirt of easy start down the intake , a really small squirt or you will lock up the engine ,t tony
Isuzu rodeo 4 cylinder sparkplug changevery important remove the cables and sparkplugs 1 at a time so you wont confuse the cables later on. i got a 97 4 cylinder. you will need 2 small extensions to reach the sparkplugs. on the top right you will have to remove with a Philip screwdriver the air hose(aprox. 3" thick) to have easy access to the sparkplugs.
show me where the starter relay is are on a 2000 Pontiac Bonneville
If your Isuzu Trooper anti-theft light is not going out and your vehicle won't start, put the key in the driver's side door and lock it. Unlock it and check to see if the alarm is disabled.
2000 catera sometimes wont start & you have to work the remote to get it to start ? Mybe it has something too do wiht the security system?????
try this. while holding pressure on the key towards start, turn the wheel to the left and then to the right in short motions but as far as you can. if the steering column is locked then the key wont turn because of pressure being put against the locking cam. if this does not work then you are probably going to have to replace the ignition.
u dont set the idle the ecm does the setting througt the air idle conrtol. If it wont idle u need to replace the aic motor on the th0rottle body!
Put gas in it - idiot