Open engine compartment,on right hand side look for the thick wires from the battery. Protected with some plastic cover ,One connection on the red wire, and earth anywhere on the body of the vehicle,(not painted)which the black wire should be connected.
If u mean steering wheel controls you need a patch lead .
it is a the rear of the air intake...right at the back /top of engine..you have little room to take out two srews ....it will have a plug lead going to it. this is on a 1.6
yes u have most likely blown the radio fuse cus the radio and heater ar the same fuse
Yes but dont jump it from the battery on the transit under the boonet there is a steel eye use that to earth the jump leads then put the red jump lead on the red lead under the bonnet its like a battery lead it will have a red plastic cover on it thats where you jump a transit from do not jump directly from the battery
you can't change a lead over a jump, but if you need to land on a particular lead what you do is; as the horse bascules, put your leg on the girth firmly on the side in which you want the horse to lead from.
the battery is under the passenger seat. However, it wouldn't be recommended to have jump leads going into your car. there should be a red cover with a plus sign or it's fell off, there should be two terminals with wires going to it. Place the red lead on there and the black lead to the bonnet release catch. Make sure you have the engine switched off both cars when doing this to avoid spark. Hope this helps.
the battery is under the passenger seat. However, it wouldn't be recommended to have jump leads going into your car. there should be a red cover with a plus sign or it's fell off, there should be two terminals with wires going to it. Place the red lead on there and the black lead to the bonnet release catch. Make sure you have the engine switched off both cars when doing this to avoid spark. Hope this helps.
theres a black box under engine with a + sign on it lift it up and put red jump lead to it and the black jump lead goes to the bonnet release catch
you need the battery first, and it needs to be in the tv remote. jump on the green button and climb on the tippy top of the tv. jump on the balloon and it will lead you to a frame jump on the following frames and jump on the shelf push the fish food
To wire an ignition barrel in the Citroen Saxo, begin by disconnecting the wire at the negative terminal of the battery. A lead wire has to go to the ACC terminal on the ignition barrel. The starter relay wire goes to the ST terminal and the ignition wire is connected to the IGN terminal.
Kenny Sailors-Wyoming
focusing too mcuh on what you already know AAPEXXX