answersLogoWhite

0

Knock sensor location 1989 suburban

Updated: 12/19/2022
User Avatar

Wiki User

14y ago

Best Answer

It is screewed into the passenger side of the engine block, JUST IN FRONT OF THE STARTER. You do not need to remove the starter to see it.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Knock sensor location 1989 suburban
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the knock sensor on a 1989 Chevy s10?

Need to know what engine it has.


What is the sensor located near the bottom of the engine on passenger side on a 1989 Chevy pickup?

That is the knock sensor


Where is the location of abs sensor on 1989 F150 pick up truck?

can i see a diagram of the location of the abs sensor on 1989 F-150?


Where do you find the knock sensor on a 1989 gm sierra truck?

As you are looking at your truck from the front the knock sensor shoud be on the passenger side right under the manifolds


Where is your knock sensor on a 1989 4.9L F150?

to the rite and just below the coil


Where is the knock sensor on a 1989 Chevrolet Caprice?

it is located on the side of the engine block.


Where is the Mass air flow sensor located on a 1989 suburban?

The 1989 did not use are even have a Mass air flow senser.


Where is the knock sensor located on 1989 Chevy Caprice?

It is located on the side of the Engine block.


How do you replace the knock sensor on a 1989 Toyota supra turbo?

the knock sensor is located on the driver side of the engine right under the intake it is about 1 in. it is connected so you will have to unplug it and then just screw it off


Where is the location of TPS sensor in Honda civic hatchback 1989?

The Throttle Position Sensor is located on the throttle body


Key code location for 1989 Chevy S10?

On original key knock out and on the side of the ignition switch.


Where is the knock sensor on 1989 Chevy Celebrity 2.8?

The knock sensor on a Chevy Celebrity 2.8 L engine from 1987 thru 1990 is located on the back side of the engine(next to the firewall) below the exhaust manifold. There are actually two sensors there, one is the knock sensor, the other is the crankshaft position sensor. The knock sensor is threaded into the block with a pipe thread, the crankshaft position sensor is held in with a 10 mm screw and is near the center of the block. They are both accessible with the engine in the car, but they are a bit of a pain to get to.l