I've had this problem twice on two different motors both time it was the spark plug.
Flex seal is good at stopping leaks but wont last long if it gets too hot.
Check your starter it may be grounded when hot.
Because the engine gets too hot. Let it cool down before you start it up again. Poor water on it.
Hi i have a r2 motor and it got hot and then wouldnt start so i replaced the water pump as it was broke and now it wont start it winds and theres spark but wont start
I would check and see how much compression you have wet and dry and start from there
The clutch is wired with a hot from the battery at all times and requires a ground from the switch to engage. Check for a bad ground wire to the clutch or a bad ground connection.
You need to buy hot start spark plugs which go on the leading plugs chamber. MAZDATRIX carries them
You need to warm the car up with hot water.
If your 97 GMC Suburban won't start when it is hot outside, check the distributor cap to ensure it is clean. You should also ensure it has plenty of coolant.
i think it wont be a hot summer
freeze plugs?
Coolant temp sensor, or leaky injectors, bad Ecu, weak battery