0
Lincoln town car 1999 4.6 engine when replacing intake manifold which gasket is best to use I have a doorman intake that takes the O-ring style gasket Can you use the one piece gasket for each?
Wiki User
∙ 12y ago
Hi there,
I am about to go thru this whole procedure this weekend. I have already purchased and received the Dorman replacement kit. From all the reserch that I have done ( and it's been a lot) There is no problem with using the "O" rings that are already installed in the replacement manifold. 2 things that are a must to remember ---- you have got to completely remove any residue from the old gasket and have the surface of the block very clean and it is very important to follow the torque sequence and apply the proper amount of torque. USE A TORQUE WRENCH DO NOT GUESS ON THIS ! Take your time with this project and good luck.
Darrel from Texas
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the fuel pump on a 1964 Lincoln Continental?
On a 1964 Lincoln it should be attached to the engine on the drivers side underneath the exhaust manifold.
Where is the thermostat located in an 89 Lincoln Town Car?
On a 1989 Lincoln Town Car , 5.0 L / 302 cubic inch V8 engine : Follow the TOP radiator hose from the radiator to the front of the engine intake manifold . The engine coolant thermostat is located in the front of the intake manifold
Why is there noticeable suction into the crankcase when the dipstick is pulled with the engine running after replacing the intake manifold gasket?
It's supposed to do that.
Can a crack in a manifold cause an oil leak?
The answer is yes. A crack in a manifold is much worse than just the oil leak. Manifold cracks are generally caused by severe overheating or improper assembly of parts. A crack in a manifold can cause oil to leak but the oil leak is inconsequential as the crack renders the engine unusable safely, without replacing the manifold. Running an engine with a cracked manifold is very bad for the rest of the engine and your own safety.
Is the intake manifold for a 1988 5.0 ford engine bronco match up with a 1988 Lincoln 5.0 engine town car?
it should be as they are both the same engine
Where is exhaust-manifold located at on a Lincoln ls 2004?
On a 2004 Lincoln LS ( 3.0L V6 and 3.9L V8 engines ) Each of the engines has ( 2 ) exhaust manifolds They are located on each side of the engine , on the sides of the cylinder heads ( there is an exhaust manifold gasket , then the manifold , and they have a heat shield over the manifold ) Your vehicle exhaust system connects to the manifolds
Must you de-pressurize system before replacing fuel filter on 1998 Lincoln?
NO....JUST SHUT THE ENGINE OFF!!!!!!!!!!!!!
On-line diagram or directions on replacing the fuel line from the engine to the fuel filter On 1991 Lincoln Town Car?
lo
What is the difference between an intake manifold and an exhaust manifold?
The intake manifold is where the air and fuel mix and enter the engine. The exhaust manifold is where unspent gas and air exit the engine. In other words the intake manifold is where the engine breathes in and the exhaust manifold is how the engine exhales out.
Will a 2005 Lincoln 3.9 engine bolt up to a 2002 Lincoln 3.9?
It will bolt up, but the throttle on an'02 is mechanical and the throttle on the '05 is electronic, the intake manifold is different and I believe the heads are different. The '02 PCM will not work with the '05 engine.
You have 1998 Astro van and have an antifreeze leak you have checked and replaced all the belts Where could it be coming from?
If it has the 4.3 ltr engine, the intake manifold is notorious for leaking at the back of the engine where you cannot see it. Try using a mirror at the rear of the intake manifold and look for wetness. Replacing the gaskey is the best fix.
Where is the thermostat on a 1990 Lincoln town car?
On a 1990 Lincoln Town Car ( 302 cubic inch / 5.0L V8 engine ) Follow the top radiator hose to the front of the intake manifold on the top of the engine . Where the radiator hose connects to the water outlet . The engine cooling thermostat is INSIDE the housing
