Toyota Trucks and SUVs

Locate oxygen sensor on 1989 Toyota truck?

789

Top Answer
User Avatar
Wiki User
Answered
2009-05-15 02:33:43
2009-05-15 02:33:43

Toyota V6 1989 Oxygen senson is located on the driver side in front of the catalytic convertor. It has four wires and held on by 2 bolts.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions



it is on under the truck on the exhaust pipe right under the drivers door



The oxygen sensor on a b2500 Mazda is located in the exhaust. It is under the truck about even with the transmission.


The computer uses the oxygen sensor reading from the exhaust to adjust the amount of fuel injected into the engine.


what is the heat sensor for a 2000 toyota tundra 4.7 lite truck.


On the 98 u have two oxygen sensors an upstream and a downstream. The upstream oxygen sensor is located closer to the front of the truck by the transmission. The downstream oxygen sensor is located on down torwards the back of the truck along the side of the frame.



In the exhaust pipes under the truck. In the exhaust pipes under the truck.


The oxygen sensor on a 98 Chevy K1500 truck is located in the exhaust manifolds. It monitors oxygen levels in the exhaust gases and allows the computer to make adjustments for optimal performance.


I've recently replaced both oxygen sensors on a 96 Tacoma 4x2. "Sensor 2" is the one after the catalytic converter. It's on the exhaust pipe, a few inches behind the converter. Held in place by 2 nuts. Electrical connection is attached to truck frame.



If the Nissan truck is either a V6 or a V8, the oxygen sensor will be located in the manifold. Sometimes it will be placed just below the manifold.


my 92 yota has a sensor. the plug is located on the passenger side of the trans.


Could be a diesel? If not then replace your oxygen sensor on your exhaust. A bad oxygen sensor causes the exhaust smoke to be dark in color.


the oxygen sensor is in the exhaust manifolds, there should be one for each side


The sensors that usually go bad in a Dodge truck are the throttle position sensor, the oxygen sensor, engine light sensor and crank sensor. These malfunctions can be fixed on any Dodge dealership.


There is not one sensor. All the ECM sensors are tied to the check engine light.


The oxygen sensor on a 1994 Chevy truck is on the drivers in the exhaust pipe right next to the manifold pointed twards the cab or the transmission.


It resides just past the catalytic converter. Underneath the truck about where the passenger would sit.


There are several O2 sensors on that truck and they are all threaded into the exhaust system at various places.


Bank 2 is the passenger side exhaust pipe and sensor 2 will be the closest sensor to the converter.


yes the oxygen sensor will cause the computer to detect a real rich fuel mixture and try to compensate for this input at the computer .


mine is not a sr5, which should be the same, has 1


Near the starter on the exhaust header. If it is 1990 it will be fun to break the rusty sensor out of the truck. good luck



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.