Take into consideration that the left side of the car/engine is the drivers side. With that in mind, it's on the left front of the engine, slightly to the left of the exhaust manifold. The sensor is held in place with a 10mm bolt. It's almost impossible to see at first glance. You have to get eye level with the top of the radiator the look towards the engine with a flashlight. I followed the wiring harness to finally find it. I used a deepwell socket with a swivel and 2) 6" extensions to reach it. If only fingers could see because it's a "feel" to get the socket on. Once the sensor retaining bolt is removed just wiggle the sensor and it will come out. Take the clip off the wiring connector and unplug old unit. Make sure the "O" ring comes out as the new sensor comes with a new "O" ring. A tiny screwdriver works fine for that. One last thing, the "O" ring needs to go all the way up to the bottom of the sensor, not just on the shaft.
Where is the crankshaft position sensor on a hyundai accent 2002
Crank Angle Sensor (location)i own a 98 Hyundai accent and the crankshaft position sensor is located just underneath the far right spark plug if your looking from the front of the car,about 5"-8". hope this helps.
its bolted to the throttle body
on the side of the throttle body.
throttle position sensor
it is the closest one to the motor
how do I replace a mass air flow sensor on a Hyundai Accent?
camshaft position sensor A Bank 1 curcuit high input
It is just next to the TPS (Throttle Position Sensor) on the intake manifold.
The IAT sensor on a 1997 Hyundai Accent is found in the piping for the intake system. The sensor will be plugged and mounted near the air box for the air filter.
The HyundaiÊ1.3 liter engine crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.
Yorksure ........:D