under pass seat
The daytime running light module on the 1992 Lumina Euro is located in the fuse panel below the steering column. On certain models, this module is found behind the glove compartment.?æ
The easiest way to bypass the antitheft module in your 1997 Buick Skylark is to remove the fuse. The location of the antitheft module fuse is listed on the inside cover of the fuse box.
Drivers side, under the washer fludid container.
The chime module is a rather large white relay box located under the dash below the glove box.
There is no such thing on Lumina. However if you're talking about the ECM (electronic control module), then you'll need to remove the coolant reservoir. The ECM is located under it.
THe airbag module you are looking for is located at the rear side of the gear, by removing the side panels around the gear the module will be visible and its easily replacable THe airbag module you are looking for is located at the rear side of the gear, by removing the side panels around the gear the module will be visible and its easily replacable
Which module are you looking for? The ECU is under the hood right in front of the black fuse box.
If you have disributorless ignition it will be mounted under the coil pack . If you vehicle still has a distributor it will be in the dist.
should be on right side, front of engine. at upper radiater hose, if not there check the thermostat housing!! on the 3.1 it is located by the ignition control module.
The ignition module on a 1989 5.7 liter is located in the distributor. Remove the cap, then the rotor, and you will be looking at the module. The module is held in place with two screws. Real simple. Good luck, David
The Electronic Control Module (ECM)/ Powertrain Control Module (PCM) is located inside the passenger compartment under the dashboard behind the relay panel. Remove the lower trim panel under the glovebox for access to the relay panel and the ECM/PCM.
The intermittent power window module for your 1996 Chevy Lumina can be found inside of the driver door. You will need to remove the door panel in order to access the power window module.