Buick Century

Low coolant reset 2001 buick century?

012

Top Answer
User Avatar
Wiki User
Answered
2014-08-21 20:44:57
2014-08-21 20:44:57

You can reset the 2001 Buick Century low coolant warning light by removing the fuse. Keep the fuse out for 10 seconds, then replace it to its original spot.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


2001 Buick Century coolant system repair costs

The 2001 Buick Century came equipped with the 3100 V6 (engine code 'J'). The cooling system capacity is 11.6 quarts.

wher is the engine temperature coolant sensor BUICK 2001

How to take out crank shaft on century 2001 buick century

what does P0650 mean on a 2001 buick century

Where is the backup light switch on a 2002 buick century?

how do you remove a sun visor on a 2001 buick regal

How do you replace the front turn signal bulb located on a 2001 Buick Century?"

what is the order of push rods for buick century custom 3.1 engine

Open the passenger front door and you will see a fuse block cover on the side of the dash. Open that cover and the red reset button is there. It is only good on low tire pressure.

The 2001 Buick Century brake light switch is located beneath the dashboard, on the drivers side. The brake light switch should be labeled as such.

You can find the 2001 Buick Century Oddie control module on the passenger side firewall. The body control module will be near the bottom of the firewall.

right side of engine compartment

You should be able to reset the low coolant light by the parking light switch 3 times on and off somewhat quickly should do it

It's on the front side of the engine, and low.

On the back side of the compressor.

It should reset itself when the coolant is back to the appropriate level as long as the sensor is working properly. If you look in the overflow reservoir and can see coolant, the sensor or wiring might be the problem.

You can add Freon to your 2001 Buick Century air conditioning system through the low pressure port. The low pressure port can be found on the top of the air conditioner compressor.

You have to find out what code the problem is. Your nearest Autozone will do that for free. Unfornately you should fix the problem then the code will reset after so many cycles of running or you have to to get it reset by dealer or buy a meter from a auto parts store that will not only give you the code but also reset it.

2001 Buick need to change the front brakes, I want to make sure there are no sensors or anything before removing them.

There are several solenoids on that vehicle. We need to know which one.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.