Want this question answered?
the energy going through the plugs is very hot and static interupting this will make the hot static electricity go to your hand.
Ear plugs.
Assuming you're talking about electrical plugs - they're made of plastic because they need to insulate the user from the electricity being fed into the device from the mains supply.
Because plastic is a good insulator from heat & electricity.
bad spark plugs and spark plugs wires, engine is missing, if plugs and wires dont work, get your engine looked at ==new answer== check your fuel filter also if your carb is stopped it will be sluggish and will sputter, also @night you can drive your car or truck for about 10 min and then look @ the catylist and if its glowing you can knock a hole in it and it will stop your sputter but changing is recommended. if that dont stop it then buy a can of seafom eng treatment and run thru fuel system from 1/2 tank of fuel this should fix problem.
You should change your plugs and use lucas oil....
The chemical energy in the battery creates electrical energy, which powers up the starter and the rest of the ignition electronics. The starter converts electrical energy into mechanical energy to spin the engine, and the electrical system creates thermal energy across the spark plug gaps (if you have spark plugs, which is most vehicles). This ignites the fuel-air mixture, and the burning of fuel is the change of chemical energy in the fuel into thermal energy. The thermal energy creates pressure in the combustion chamber, and this pressure increase is mechanical energy. That mechanical energy forces the piston down, and the mechanical energy is eventually transferred to the wheels to move the vehicle.
Change spark plugs tp Platinum and Silicone plug wires and use Lucas Upper Cylinder Lubricant.
Yes. Your Check Engine light or Service Engine Soon light.
did you change the wires also. if not you probablly have a loose wire for one of the plugs. does it run any different
A noid light is a test light that plugs into your harness of the fuel injectors to test for electrical pulses.
Part of ignition system. Stores energy to fire plugs.
the energy going through the plugs is very hot and static interupting this will make the hot static electricity go to your hand.
The Chevrolet Colorado brake light switch is quite simple to change. The brake light switch simply plugs in and out.
if the engine light is blinking a misfire condition has been detected. check plugs and wires.l
i have replaced the plugs and wires and my service engine light comes again in 2004 land rover discovery
The brake light switch can be found below the dashboard on the drivers side of the passenger compartment. The brake light switch simply plugs in and out.